Tack is good and non-degumming, adhesion reaches 7.6 N/cm, mass performance is stable, suitable for cross-cut adhesion testing, to ensure accurate film integrity assessment.
Adopting the test principle of inclined rolling ball method, the tilt angle adjustment range is 0~ 40 °, equipped with 32 GCr15 bearing steel balls, and the shape tolerance accuracy exceeds GB/T308 level 40 to achieve accurate initial Tack evaluation.
Adopting permanent magnet DC motor and augmented speed line to achieve 0-3000rpm stepless speed regulation, with 40W Power output, smooth operation and 120-minute timing function.
Adopt permanent magnet DC motor, Power 140W, Speed range 0~ 1100rpm, support boosting function and unified speed regulation, and can still work stably in a solution with strong viscosity.
Adopt permanent magnet DC motor to achieve stepless speed regulation, the speed range starts to 1100rpm, the four-station design can be synchronized Stir, enhance corrosion resistance, suitable for high viscosity solution treatment.
Adopting permanent magnet DC motor with augmented speed line to achieve stepless speed regulation of 0-3000rpm, with 160W Power output, smooth operation and no need to replace carbon brushes, medium speed stirring can reduce vibration and prolong life.
Adopting permanent magnet DC motor with augmented speed line to achieve 0-3000rpm stepless speed regulation, with 100W Power output, smooth operation and no need to replace carbon brushes, medium speed stirring can reduce vibration.
Adopting permanent magnet DC motor with augmented and stable speed line to achieve stepless speed regulation at 0-3000rpm, smooth operation and sufficient torque, medium speed operation can reduce vibration and prolong service life.
Adopt permanent magnet DC motor to achieve stepless speed regulation of 0-3000rpm, support 0-120 minutes timing control, equipped with stainless steel stirringRod corrosion resistance, independent control box can be operated remotely, and the operating noise is less than 40 decibels.
Using permanent magnet DC motor to achieve stepless speed regulation of 0-3000rpm, equipped with PWM DC speed regulation technology to ensure stable speed, independent control box design can be remotely operated, noise below 40 decibels suitable for laboratory environment.
Adopt permanent magnet DC motor to achieve 0-3000rpm stepless speed regulation, equipped with PWM DC speed regulation technology to ensure stable speed, noise is lower than 40dB, support 0-120 minutes timing operation, to meet the Stir requirements of different viscosity samples.
Humidity environment can be simulated according to the national standard design, with 500g measuring device and 1cm ² flat bottom area, easy to operate and accurate results.
The equipment tests the initial Tack by short contact between steel ball and adhesive tape sample at a small pressure, adjustable tilt angle 0~ 60 °, rolling ball range 1/32 inch to 1 inch, suitable for a variety of material adhesion evaluation.
Adopting the principle of the inclined rolling ball method, the adhesion is measured by the short contact between the steel ball and the sample, the adjustment range of the tilt angle is 0-60 °, and the rolling ball of 1/32 to 1 inch is supported. The width of the test area is 80mm.
Three stations can be tested simultaneously, with a maximum time of 99 hours, 59 minutes and 59 seconds. Imported proximity switches and laser cross-cut test boards are used to ensure data accuracy and equipment durability.
