Specially designed for short bars, it provides daily storage, cleaning and maintenance functions, and meets the ASTMD823-53 standard, which can improve the efficiency of bar use and extend its life.
Designed for long bars, it can store multiple Rods at the same time, conforming to ASTMD823-53 standard, which is convenient for daily cleaning and maintenance operations and effectively extends the service life of the tool.
With 0~ 300rpm stepless speed regulation and 20mm swing amplitude, the multi-functional spring bottle test rack supports a variety of comparison experiments, and the low center of gravity of the whole machine ensures stable and reliable continuous work.
With a multi-functional spring bottle test rack, it supports a variety of comparative experiments; the stepless speed range is 0~ 250rpm, and the pendulum amplitude is 25mm; the center of gravity of the whole machine is low, and the continuous work is stable and reliable.
Rated load 500N, rack and pinion drive, hand pressure operation is simple and stable, large foot design to ensure smooth measurement process, Travel 75mm, suitable for Force Gauge installation for tensile or plug force test.
Wet film thickness 22.9 microns, diaMeter 9.52 mm, the forming Rod uses an extrusion process to process continuous grooves, with no wire breakage and easy cleaning; the wire-wound Rod is based on the traditional principle, and there are differences in coating amount.
Double pointer design can be used with rack or hand, pressing needle Travel 0-2.5 mm, measurement error +/- 1HA, suitable for rubber and plastic hardness testing.
The continuous groove structure is made by extrusion process, the wet film thickness is 22.9 microns, the application width is 300mm, and it has the characteristics of continuous wire and easy cleaning.
A groove control film is formed on the smooth Rod body by extrusion process. The wear-resistant stainless steel material is not easy to break the wire and is easy to clean. The wet film thickness is 105.2 μ m and the application width is 300mm.
Using 300mm × 300mm stainless steel inner Tank, equipped with heating temperature control function, support timing operation and drawer sample stage, to ensure safe and efficient cleaning process.
Adapted diaMeter 16mm formed Metering Rod, the total length of 2000mm, through the special structure to correct the straightness of the Rod body, to ensure stable rotation and full contact with the substrate, improve the thickness control accuracy of Spreader.
Equipped with 40KHz Ultrasonic Frequency and 100W Heating power, it supports 1-30 minute timing and 20-80 ℃ temperature control to ensure deep cleaning and rapid dirt removal.
With ultrasonic and degassing two cleaning modes, support 14 temperature within 80 ℃ precise control and 60 minutes timing. SUS304 stainless steel punching Tank without solder joint design, the transducer conversion rate is high, long service life.
Equipped with 40KHz Ultrasonic Frequency and 100W Heating power, support 1-30 minutes timing and 20-80 ℃ temperature control, inner Tank size 240 × 140 × 10mm, improve cleaning efficiency.
Using a formed pRoduction process, the wet film thickness is 52 microns, the application width is 300 mm, and the stainless steel material ensures durability and easy cleaning, suitable for hand-held operation.
