Equipped with 2 to 12mm eight diaMeter stainless steel cylindrical mandrel, in the form of hinged bending, in line with GB6742 standard, suitable for Coating bending performance testing.
It can test the cracking of the paint film after bending 180 degrees in 1-3 seconds, and the diaMeter range of the shaft Rod is 2-32mm. It is suitable for the test plate with a thickness of not more than 1.0mm. Quick evaluation of flexibility.
Equipped with 8 kinds of diaMeter shaft Rods from 2 to 12mm, the 180 degree bending test can be completed in 1-3 seconds, and the anti-cracking performance of the paint film can be evaluated with the smallest shaft Rod diaMeter, which is easy to operate.
Equipped with 13 kinds of diaMeter shaft Rods, covering the range of 2-32mm, can detect 1.0mm thickness samples, evaluate the film anti-cracking performance through different bending radii, easy and accurate operation.
The instrument is equipped with eight kinds of diaMeter stainless steel cylindrical mandrel, which adopts the form of hinge connection bending, which can accurately test the bending deformation of coatings under different diaMeters to ensure the test Reliability.
Using pure mechanical design, the coating performance is measured by conical mandrel bending test plate, the test plate size is 100mm × 180mm, the thickness is less than or equal to 0.8mm, and the operation is simple and reliable.
The tapered shaft size range is 3.2~ 38mm, and the shaft length is 203mm, which can test the cracking and disbonding performance of the paint film under bending conditions, in line with international standards.
Equipped with 12 high-Hardness stainless steel shaft Rods, with a diaMeter range of 2-32mm, it supports two test methods to determine the cracking resistance of coatings, and the clamping device is designed for easy plate fixing and shaft Rod replacement.
Using conical mandrel design, can measure the cracking resistance and elongation of the coating, the thickness of the test plate supports 0.8mm, easy to operate without power supply, to meet a variety of standard test requirements.
Tapered shaft size Φ 3.1~ 38mm, shaft Rod size 2-32mm, anodic oxidation aluminum and stainless steel material, ergonomic design clamping device, bending arm large knob for easy operation, suitable for measuring plate thickness ≤ 0.8mm.
The conical mandrel bending range is 3.1 to 38mm, and the plate thickness can be tested by 0.8mm. The panel is instantly locked and unlocked with a fast lever handle, which is convenient for operation.
Measurement width 200mm, thickness within 1.5mm test plate, stainless steel cone diaMeter range 3.2-38 mm, anodic oxidation aluminum material, complete 180 ° bending test within 15 seconds.
The cone shaft length is 203mm and the large end diaMeter is 38mm, which can test the cone bending resistance of a single layer or the entire coating system separately. Operating temperature is 23 +/- 2 ℃ and relative humidity is 50 +/- 5%.
Equipped with 8 kinds of diaMeter shaft Rods of 2-12mm, made of wear-resistant stainless steel, easy to operate without assembly, each shaft Rod is engraved with diaMeter numbers for easy identification and use.
The test bending angle is less than 45 degrees, suitable for steel plate thickness 0.5~ 1.0mm and Aluminum Panel thickness 0.5~ 2.0mm. The gear pair and crank lifting mechanism are used to achieve T-shaped bending, which is easy to operate.
