The equipment tests the initial Tack by short contact between steel ball and adhesive tape sample at a small pressure, adjustable tilt angle 0~ 60 °, rolling ball range 1/32 inch to 1 inch, suitable for a variety of material adhesion evaluation.
Using double-sided uniform tin plating process, the surface mass reaches class I, Hardness is T52, standard thickness is 0.28mm, to ensure accurate and reliable film test results.
Using silicon carbide Rod double-sided heating, rapid heating and high thermal efficiency; maximum temperature 1200 ℃, temperature control accuracy +/- 5% ℃; PID microcomputer control combined with K-type Thermocouple, temperature accuracy and stability.
Using imported Sensor and motor, Measurement range 0~ 200N, accuracy less than +/- 1%, can store 20 sets of data and automatically print reports, support a variety of substrate replacement.
Measurement range 0~ 500N, accuracy less than +/- 1%, can store 20 sets of results and print reports, humanized fixture supports a variety of substrates.
Sensor and motor imported, Measurement range 0~ 300N, accuracy less than +/- 1%, can store 20 sets of data and automatically calculate the maximum, minimum, average, support a variety of substrate testing.
Using imported Sensor and motor, Measurement range 0~ 50N, accuracy less than +/- 1%, can store 20 test results and print reports, humanized fixture supports changing substrate.
The adhesive force of the tape is 4.3N/cm, and the principle of cross-cut method is adopted, which is suitable for adhesion testing. The performance is stable and non-degumming, and the test results are accurate and reliable.
Tack is good and non-degumming, adhesion reaches 7.6 N/cm, mass performance is stable, suitable for cross-cut adhesion testing, to ensure accurate film integrity assessment.
Adopting the principle of the inclined rolling ball method, the adhesion is measured by the short contact between the steel ball and the sample, the adjustment range of the tilt angle is 0-60 °, and the rolling ball of 1/32 to 1 inch is supported. The width of the test area is 80mm.
Using CR12 molybdenum vanadium material double edge structure, film thickness 500μm/600μm, U-shaped design to achieve fast Spreader, effective application width 80mm, total length 100mm, suitable for wet-film preparatory.
Double-sided design can provide 75/150μm two kinds of wet film thickness, effective Spreader width 12.7mm, wear-resistant corrosion-resistant alloy steel material to ensure accurate control of film Film thickness, to ensure coating conformity and Repeatability.
Double-sided different film Film thickness design, wet film thickness 150/200μm, Spreader width 80mm, wear-resistant corrosion-resistant alloy steel material, suitable for a variety of materials experimental film preparatory.
The double-sided design can provide two wet film thicknesses of 38μm and 76μm, the effective Spreader width is 12.7mm, and the alloy steel material is wear-resistant and corrosion-resistant to ensure coating conformity and Repeatability.
Double blade design can be prepared 75μm or 100μm two wet film thickness, effective application width 80mm, using molybdenum vanadium material, suitable for film proofing.
