With four adjustable friction Frequency 21/43/85/106cpm, friction load 20N, support linear reciprocating friction movement, power-off memory function to ensure that paraMeters are not lost, effective analysis of coating adhesion and wear resistance performance.
Can test inks multi-directional adhesion at the same time, Friction Frequency 43cpm, Friction Load 2lb/4lb, Abrasion Resistance evaluation by measurement density or Coating thickness reduction, support 0-99999 automatic shutdown.
It can simultaneously print color bars of different Colors or Ink Film thickness, detect inks Hue and Gloss, uniform ink time can be adjusted from 1 to 800 seconds, support dry and wet ink discoloration analysis and abrasion resistance testing.
Using 15.5cm/min ink wiping speed, equipped with 0.1mm ink coating platen, the test process is precisely controlled by 4.3 inch Touchscreen, which can accurately determine the absorption capacity of the material to the inks vehicle.
Using reciprocating motion to simulate transportation abrasion, Friction Frequency 0~ 2.5Hz adjustable, Test Travel 12.7~ 50.8mm, support continuous test 0~ 24 hours, suitable for a variety of can sizes and pressure conditions.
Automatic ink running stability, ink time and speed can be set, printing pressure 0~ 2mm adjustable, provide low, medium and high three printing speed, each time can be proofed 4 colors to facilitate Color contrast.
The ink wiping speed of the instrument is 15.5 +/- 25px/min, the ink absorption time is 120 +/- 5s, and the 4.3 color Touchscreen control can accurately evaluate the acceptance of inks and the absorption capacity of the vehicle.
The device can precisely control the film thickness of the ink layer of the color strip, and the ink injection amount is 0.0012g, which is used for ink contrast and color concentration detection.
Scruf Travel 20-300mm adjustable, speed range 1-60cpm, equipped with TFT full color display and intelligent Operating interface, supports manual testing and is compatible with a variety of standard accessories, suitable for coating Abrasion Resistance evaluation.
The ink wiping speed is 15.5cm/min, the opening area of the ink coating platen is 20cm ², and the ink absorption time is 120s. The test process is automatically controlled to accurately determine the absorption capacity and penetration performance of the paper to inks.
Adopt reciprocating friction method, Friction Frequency 0~ 2.5Hz, Test Travel 12.7~ 50.8mm, can simulate coating abrasion during transportation, support continuous test 0~ 24 hours.
Driven by numerical control motor, swirl/spin accuracy of 0.1 degrees, support multi-color inks Hue, concentration detection, can anticipate dry and wet ink color change and Abrasion Resistance, 5-10 minutes rapid color development, significantly reduce inks waste.
The equipment supports 0-2MM pressure adjustment, providing three-speed printing speed (10/15/20 rpm) and uniform ink speed (650/800/1000rpm), which can imprint 2.5mm thick paper and 1mm plastic film to achieve precise uniform ink and stable operation.
Measurement range 0~ 1250μm, suitable for LEEB220 and LEEB222 Coating thickness Gauge, Abrasion Resistance is good, suitable for a variety of nonmagnetic Coating thickness detection.
The ink wiping speed is 15.5 +/- 1.0cm/min, the opening area of the ink coating platen is 20 +/- 0.4cm ², and the ink absorption time is 120 +/- 5s. It is controlled by 4.3 inch color Touchscreen, which is suitable for the absorption performance measurement of paper inks.
