It adopts copper ring and steel ball structure, supports 2-3.55 gram steel ball configuration, and accurately determines the softening temperature of the material through the drop distance of 25.4 mm, which is suitable for all kinds of asphalt experiment needs.
Automatically detect the drop point and softening point of amorphous polymer compounds, temperature resolution 0.1 ℃, heating rate adjustable eight gears, in line with ASTMD3461-97 standard, easy to operate and strong sense of cleanliness.
Support thermal deformation and Vicat softening point test, Temperature range up to 300 ℃, Temperature control accuracy +/- 0.5 ℃, mechanical mixing and large capacity Tank to ensure uniform insulation field, double control mode operation flexibility.
Dual channel simultaneous detection, Temperature range RT +~ 360 ℃, high-resolution video real-time observation and recording of the whole process, support 0.1 ℃/min -20 ℃/min continuous heating rate, easy to verify the results.
Adopt high definition camera to observe the measurement process in real time, dual-channel simultaneous detection, adjustable heating rate 0.1-20 ℃/min, support video playback and automatic interpretation of deformation characteristics.
Temperature range RT +~ 300 ℃, heating rate 120 +/- 10 ℃/h, with sample rack lifting function, automatic stop heating at the end of the test, printable report Linear dispersion, suitable for Non-metallic material testing.
The Benchtop structure supports three-station testing, and the control accuracy of the constant rate heating algorithm reaches +/- 0.5 ° C. The data can be automatically recorded and exported to Excel. Transformer oil or methyl silicone oil is used as the heat conduction medium to ensure uniform heat preservation field.
Temperature range RT +~ 300 ℃, heating rate 120 ℃/h or 50 ℃/h, maximum deformation Measurement range 1mm, support thermal deformation and Vicat test, real-time display and alarm function.
Four-ring Conductivity Detector Probe with three Measurement ranges (0.0 to 199.9 mg/L, 0 to 1999 mg/L, 0.00 to 19.99 mg/L), manual temperature compensation and single point calibrating ensure easy operation and accurate measurement in different environments.
Precision combination of cutting edge to ensure that the sample edge flat, especially for ring pressure test design, can cut standard samples, easy to operate, cutting effect is good.
Equipped with 13 sub-disks and 1 master disk, the clamping thickness range is 0.1-1 mm, and the accuracy deviation is less than or equal to 0.01mm. It is suitable for Ring Crush Test testing requirements of different thickness papers.
Dimensions of special-shaped support ring, suitable for HM6560 Leeb Hardness Tester, ensure stable support on complex surfaces, improve Measurement accuracy and applicability.
High sampling accuracy, support 152 × 12.7mm ring pressing and (200~ 250) × 15mm stretching, folding resistance, blade combination precision to ensure that the sample edge is flat, easy to operate.
With automatic return and crushing force judgment function, support three adjustable speeds, capacity 0~ 30000N, accuracy +/- 1%, can automatically convert the ring edge pressing strength and comes with stacking test.
The equipment tests the initial Tack by short contact between steel ball and adhesive tape sample at a small pressure, adjustable tilt angle 0~ 60 °, rolling ball range 1/32 inch to 1 inch, suitable for a variety of material adhesion evaluation.
