The length of the stainless steel blade is 100mm, with a wooden handle, the total length is 200mm, which is rust-proof, durable and comfortable to operate.
Using reciprocating motion to simulate transportation abrasion, Friction Frequency 0~ 2.5Hz adjustable, Test Travel 12.7~ 50.8mm, support continuous test 0~ 24 hours, suitable for a variety of can sizes and pressure conditions.
Can test inks multi-directional adhesion at the same time, Friction Frequency 43cpm, Friction Load 2lb/4lb, Abrasion Resistance evaluation by measurement density or Coating thickness reduction, support 0-99999 automatic shutdown.
Scruf Travel 20-300mm adjustable, speed range 1-60cpm, equipped with TFT full color display and intelligent Operating interface, supports manual testing and is compatible with a variety of standard accessories, suitable for coating Abrasion Resistance evaluation.
Using wooden handle material and high-quality alloy steel blades, the tooth spacing is 2mm, the number of teeth is 6, the top width of the blade is less than 0.05mm, the included angle is 30 ° +/- 1 °, suitable for film Film thickness 61μm~ 120μm hard substrate or Film thickness < 120μm soft substrate, ergonomic design is labor-saving, and the blade can be easily replaced.
Adopt reciprocating friction method, Friction Frequency 0~ 2.5Hz, Test Travel 12.7~ 50.8mm, can simulate coating abrasion during transportation, support continuous test 0~ 24 hours.
The fixture can fix the upper and lower ends of the butterfly specimen into a vertical shape, test the vertical compression strength, suitable for a variety of Corrugated Board types, Dimension 150 * 105 * 65mm, weight about 2Kg, easy to operate.
Suitable for a variety of Corrugated Board adhesive strength test, equipped with different specifications of steel needles, needle diaMeter range 1.0-3 mm, support A, B, C, E corrugated test, sample size 25 × 80mm.
Measurement range 0~ 1250μm, suitable for LEEB220 and LEEB222 Coating thickness Gauge, Abrasion Resistance is good, suitable for a variety of nonmagnetic Coating thickness detection.
Support 100 ° C high temperature treatment, compatible with 96-well 0.2ml standard board design, can be matched with a variety of centrifuge tube modules, to achieve flexible experimental configuration and efficient Sample Handling.
With four adjustable friction Frequency 21/43/85/106cpm, friction load 20N, support linear reciprocating friction movement, power-off memory function to ensure that paraMeters are not lost, effective analysis of coating adhesion and wear resistance performance.
Thrust sampling mode, cutting edge pressure sample 25mmx100mm and gluing sample 25mmx80mm, sampling thickness range of 18mm, suitable for Corrugated Board and carton mass detection.
Can cut 25 * 100mm sample, sampling error +/- 0.5mm, sampling thickness range of 18mm, fast and accurate completion of Corrugated Board Edge Crush Test and adhesive strength test sample preparation.
It can cut 32.2cm ² and 64.5cm ² samples, the sampling error is less than 0.5cm ², and the maximum sampling thickness is 15mm, which meets the accurate sampling requirements of Corrugated Board Flat Crush Test.
Using standard sand free fall brushing layer, straight grinding to expose 4mm substrate; can quantify the abrasion per unit thickness of the paint layer of sand volume, the inner diaMeter of the catheter 19mm, sample holder 45 degrees angle fixed.
