Scruf Travel 20-300mm adjustable, speed range 1-60cpm, equipped with TFT full color display and intelligent Operating interface, supports manual testing and is compatible with a variety of standard accessories, suitable for coating Abrasion Resistance evaluation.
Scruf Travel 20-300mm adjustable, with +/- 1% speed accuracy, equipped with TFT display and intelligent Operating interface, supports multiple languages and accessories expansion.
Scruf Travel 300mm, speed 37cpm, total weight of brush and brush holder 450g, suitable for architectural coatings coating scrub resistance testing, in line with national standards.
Using DC stepper motor drive and module slider system, smooth and safe operation; double brush combination can do two tests each time, brush movement Frequency 37 times/minute, peristaltic pump control adjustable liquid Flow velocity.
The equipment is designed according to the international coating stain resistance experimental method, the water Tank volume is 5L, the inner diaMeter of the flow pipe is 8mm, and the time control range is 0~ 99h99s. It is suitable for the stain resistance test of building exterior coatings.
4-Terminal Resistance Measuring method is used to eliminate the influence of wire resistance. Test speed is up to 6 times/sec. Measurement current is less than 100mA to prevent temperature drift and ensure Precision and Stability.
Using 2-wire method and 3-wire method measurement, Ground Voltage Measurement range 0~ 200V, Ground Resistance Measurement range 0~ 1999 Ω, Response Time about 5 seconds, with continuous measurement and overload protection function.
Double grinding head assembly configuration, total weight 1500g, Reciprocating Frequency 37 +/- 2 times/min, Travel 300mm, can accurately evaluate the stain resistance of the film.
With four adjustable friction Frequency 21/43/85/106cpm, friction load 20N, support linear reciprocating friction movement, power-off memory function to ensure that paraMeters are not lost, effective analysis of coating adhesion and wear resistance performance.
The use of national standard 06Cr19Ni10 stainless steel precision machining, high temperature resistance up to 300 ℃, low temperature resistance to -100 ℃, hardness ≤ 187HB, with acid and alkali resistance, grinding anti-sinking, anti-stick, suitable for dry grinding and wet grinding.
With two test stations, the load range is 50~ 1000g, and three typical wear resistance tests of alcohol, eraser and pencil can be carried out, which is suitable for wear resistance evaluation of various coatings and materials.
Can reduce the contact resistance of 35~ 95% and temperature rise of 35~ 85%, high temperature resistance up to 200 ℃, with anti-oxidation, anti-corrosion performance, suitable for a variety of metal connections, improve safety and stability.
Conical mandrel size is 3.1~ 38 mm, length 203 mm, stainless steel material, wear resistance and corrosion resistance, can test the bending performance of steel, aluminum alloy and plastic sample, easy to operate.
The equipment has a 15-liter large-capacity water Tank and an 8mm inner diaMeter water pipe, supports 0 to 99 hours of time control, adopts stainless steel structure and automatic control device, and is suitable for coating stain resistance testing.
Steel ball diaMeter 1mm needle, load range 0-2000g, through the minimum load of the film to accurately determine the coating resistance to penetration, traverse speed 30-40mm/s to ensure the test Stability.
