Electrochemical sensor, formaldehyde detection range 0-20ppm, resolution 0.1ppm, with sound, light, vibration triple alarm, IP65 Protection Rating, built-in 1500mAh lithium battery can work continuously for 8 hours.
The stainless steel inner box is used to ensure non-adsorption formaldehyde, the background concentration is as low as 0.006mg/m ³ and the holding time is long; Temperature range 15-40 ℃ accuracy +/- 0.5 ℃, humidity range 30-80% RH accuracy +/- 3%; low failure rate, the average initial maintenance interval exceeds 3 years.
It can simultaneously detect 7 paraMeters such as PM2.5, formaldehyde, and TVOC, with an accuracy of +/- 10%. It is equipped with a 2.8-inch true color screen to display real-time trend charts, and supports 5000 data records and dual national standard selection.
Pump-suction Sampling method, detection accuracy ≤ +/- 3%, resolution of 0.01ppm, Response Time T90 ≤ 20 seconds, built-in large-capacity battery, support for multi-Sensor expansion, with IP65 Protection Rating.
Using 32-bit microprocessor and 24-bit ADC chip, equipped with 2.4-inch high definition color screen, supports 1-6 Sensor configurations, with 4-20mA output and RS485 communication, Protection Rating IP65, suitable for harsh environments.
MCU chip to achieve low power operation, equipped with intelligent Sensor to ensure detection accuracy ≤ +/- 3% F. S, Response Time ≤ 30 seconds, support 4-20mA, RS485 and switching signal output, easy access to various industrial control systems.
Adopt MCU chip to achieve low power consumption operation, detection error ≤ +/- 3% F. S, Response Time ≤ 30 seconds, support 4-20mA, RS485 and switch output, can be operated by remote control without opening the lid, with explosion-proof protection structure.
Using 3.5mm Probe and 10mm insertion depth, Measurement range 0.5~ 15.0kgf/cm ², with average calculation, MAX Maximum latch function, support USB, RS-232 and Bluetooth Data output methods.
The melting temperature error is only +/- 1 ° C, allowing for remote observation of the melting state. It can be directly pasted without complex installation and is suitable for temperature monitoring of a variety of electrical equipment.
Adopt photometric 90 ° scattering measurement method, equipped with automatic cleaning brush and bubble measurement cell, support automatic sewage discharge and cleaning interval setting, Measurement range 0.00-500 NTU, Repeatability ≤ 2%.
Adopt air jacket indirect temperature control to avoid condensation, dry moisture ratio control humidity Response fast, background concentration as low as formaldehyde ≤ 0.006mg/m ³, support automatic temperature control and humidity control and multiple safety protection, suitable for material environmental protection assessment.
The rated temperature is 55 ° C and the error is only +/- 1 ° C. The melting situation can be observed remotely, and it can be directly pasted for use in busbars or equipment terminals to monitor temperature changes.
Adopt formaldehyde shell to ensure durability, built-in temperature sensor real-time compensation, dual range coverage 0~ 20mg/L and 0~ 200% Saturation, can add reference solution maintenance calibrate, suitable for a variety of dissolved oxygen measurement scenarios.
Maximum 4 kinds of gas simultaneous detection, integrated temperature and Humidity monitoring, with sound and light alarm function, Response Time T90 ≤ national standard, Protection Rating IP66, suitable for a variety of Installation methods.
Maximum support for simultaneous detection of 4 gases, integrated temperature Humidity detection, dual temperature Humidity compensation design, with a variety of wireless communication options, Response Time T90 ≤ national standard, Protection Rating IP66.
