Using formed process, wet film thickness 35 microns, application width 400mm, continuous wire, uniform film and good repRoducibility, easy to clean after the experiment.
Using 160 * 280mm size, with wire Rod scraping ink to ensure that the film is flat, Glass table is conducive to operation and observation effect.
Using 180 * 480mm size, with wire Rod or Film Applicator scraping ink, is conducive to the film flat and effective, improve film mass.
Adopting spiral trapezoidal screw, it has the characteristics of manual operation, simple stability, vertical and lying dual-use, the maximum load is 500N, and the tensile force is Travel 200mm. It is suitable for tensile and compressive load, insertion and unplugging force, and failure test.
Glass material is conducive to film flatness, size 230 * 340mm, with wire Rod or Film Applicator for scraping operation is more effective.
Using 140 wire metal anilox roller to control ink film thickness, flexographic samples can be quickly prepared, easy to use and clean, and high repRoducibility.
Using 100 wire metal anilox roller to control ink film thickness, it can quickly prepare flexographic samples, easy to operate and clean, and good repRoducibility.
Using 400 wire metal anilox roller to control the ink film thickness, flexographic samples can be quickly prepared, easy to use and clean, and the repRoducibility is very similar to that of conventional flexographic printing.
Glass material ensures that the film is flat, used with wire Rod or Film Applicator, the specification size is 110 * 180mm, and the operation is simple and efficient.
Adopt trapezoidal screw drive and integral nut design, rated load 500N, Travel 150mm, can be firmly clamped to prevent partial load, fast loading and unloading to improve measurement accuracy, vertical and horizontal dual-use to adapt to a variety of test scenarios.
Using 180 wire metal engraving roller to control the ink film thickness, four pyramidal mesh structure to ensure uniform Spreader, simple operation and easy cleaning, can quickly prepare samples similar to flexographic printing effect.
Coating thickness control of 4-120μm using wire-wound structure, spiral winding design up to 500μm thickness, with 220mm application width and 0.64mm wire diaMeter to ensure Spreader uniformity.
Wet film thickness 22.9 microns, diaMeter 9.52 mm, the forming Rod uses an extrusion process to process continuous grooves, with no wire breakage and easy cleaning; the wire-wound Rod is based on the traditional principle, and there are differences in coating amount.
Using 500 wire stainless steel anilox roller and quadrilateral pyramid mesh hole, the thickness of INKS film can be precisely controlled, flexographic samples can be quickly prepared, and cleaning and maintenance are convenient.
Wire-wound design can achieve 80 micron wet film thickness, diaMeter 9 mm, total length 245 mm, suitable for comparison specimens, one Spreader can handle a variety of Coatings.
