Using 12 stainless steel shaft Rods with a diaMeter of 2-32mm, the 50mm wide test plate can be tested for 180 ° bending. The coating cracking situation is detected by decreasing the diaMeter of the shaft Rod, and the operation is simple and fast.
Tapered shaft size Φ 3.1~ 38mm, shaft Rod size 2-32mm, anodic oxidation aluminum and stainless steel material, ergonomic design clamping device, bending arm large knob for easy operation, suitable for measuring plate thickness ≤ 0.8mm.
Equipped with 8 kinds of diaMeter shaft Rods from 2 to 12mm, the 180 degree bending test can be completed in 1-3 seconds, and the anti-cracking performance of the paint film can be evaluated with the smallest shaft Rod diaMeter, which is easy to operate.
Equipped with 13 shaft diaMeters from 2 to 32mm, it can accurately determine the cracking performance of coatings; support 1.0mm thickness sample testing, manual operation to ensure smooth and controllable bending process, meeting standard laboratory Environmental requirements.
Equipped with 2 to 12mm eight diaMeter stainless steel cylindrical mandrel, in the form of hinged bending, in line with GB6742 standard, suitable for Coating bending performance testing.
The tapered shaft size range is 3.2~ 38mm, and the shaft length is 203mm, which can test the cracking and disbonding performance of the paint film under bending conditions, in line with international standards.
The cone shaft length is 203mm and the large end diaMeter is 38mm, which can test the cone bending resistance of a single layer or the entire coating system separately. Operating temperature is 23 +/- 2 ℃ and relative humidity is 50 +/- 5%.
Equipped with a total of 12 shaft Rods of 2-32mm, it can test the 1.0mm thickness sample, and test the anti-cracking performance of the coating through 180 ° bending, which is easy to operate and accurate.
The cone shaft is used to test the anti-cracking performance of coatings with different curvatures. The size of the cone shaft is Φ 3.1~ 38mm, the volume is small and the weight is light, which is convenient for laboratory and field use.
Equipped with 13 kinds of diaMeter shaft Rods, covering the range of 2-32mm, can detect 1.0mm thickness samples, evaluate the film anti-cracking performance through different bending radii, easy and accurate operation.
Equipped with 8 kinds of diaMeter shaft Rods of 2-12mm, made of wear-resistant stainless steel, easy to operate without assembly, each shaft Rod is engraved with diaMeter numbers for easy identification and use.
Support 0.1-1 steel plate and 0.1-2 Aluminum Panel test, can complete 0T to 1T multi-stage bending, equipped with pliers pressing device and tape adhesion inspection function, to meet the standard bending test process.
Maximum load 100KN, suitable for bending testing of various materials, with high load-bearing capacity and Stability, to meet different testing requirements.
A bending angle is less than 45 degrees, can test 0.5~ 1.0mm Film thickness sample, flattening mechanism stroke is not less than 10mm, using crank lifting mechanism to achieve T-shaped bending test.
The instrument is equipped with eight kinds of diaMeter stainless steel cylindrical mandrel, which adopts the form of hinge connection bending, which can accurately test the bending deformation of coatings under different diaMeters to ensure the test Reliability.
