Speed range 0~ 20000rpm wide adjustable, equipped with high-speed series motor and stable silicon control system, integrated photoelectric speed measurement to ensure accurate reading, compact structure and convenient operation.
Adopt thyristor high-speed adjustment system, photoelectric speed measurement electronic circuit to ensure reliable Rotation speed, homogenization knife Speed range of 22000rpm, Processing capacity 1000ml, easy to operate and intuitive reading.
With a wide speed range of 0~ 10000rpm and 280mm lift Travel, using frequency conversion electromechanical operation quiet noise, support high-speed dispersion, stirring and grinding functions, suitable for 0~ 2L Processing capacity.
The equipment integrates stirring, dispersing, grinding functions, motor Power 750W, speed range 60~ 8000rpm, can handle materials with a viscosity of 100000mPa.s, through high-speed swirl/spin to generate strong shear force to achieve efficient Mixing & dispersing.
High Accuracy Imported Sensor, Measurement accuracy up to 0.001N, test stroke 0-320mm adjustable, speed range 1-1200mm/min, support arbitrary slider mass setting, real-time display of force value Linear dispersion, automatic calculation of static and dynamic Coefficient of Friction.
Rotation speed up to 12,000 rpm, driven by vertical single-phase series motor, Power 200W, compact size and low power consumption, can be split, crushed and blended to meet the requirements of aseptic operation.
Using microcomputer control to achieve automatic testing, equipped with High Accuracy force sensor accuracy of 0.001N, special drive system running smoothly, can simultaneously measure static friction and dynamic Coefficient of Friction.
Based on the national standard design, the static Coefficient of Friction and the dynamic Coefficient of Friction can be measured simultaneously, with a test accuracy of up to 0.001N, equipped with High Accuracy Sensor and special drive system to ensure smooth operation and accurate results.
Automatic measurement and display of dynamic and static Coefficient of Friction, Measurement accuracy +/- 1%, slider traverse speed 100mm/min, stable performance, accurate testing, complete functions, easy to operate.
Using microcomputer control to achieve automatic testing, equipped with High Accuracy force sensor accuracy of 0.001N, special drive system running smoothly, can simultaneously measure static friction and dynamic Coefficient of Friction.
Using reciprocating friction method, friction load 500g, Friction Frequency 40 +/- 2 times/minute, can simulate drying or wet conditions for material wear-resistant decolorization test.
Sampling speed up to 1920HZ, accuracy level 0.5, support three units of automatic conversion and a variety of test mode, with data storage and qualified judgment function, suitable for high-speed Impact torque detection.
Sampling speed up to 1920Hz, equipped with three test modes and 99 sets of data storage, can automatically calculate statistical values and support upper and lower limit qualification judgment, suitable for high-speed Impact twist detection scenarios.
Driven by a series-excited micro high-speed motor, the processing viscosity reaches 5000cp, Speed range 300-23000rpm stepless speed regulation, built-in soft start and overload protection, support long-term continuous operation.
Adopt 0.5 High Accuracy Force Value Sensor, Force Value Acquisition Frequency 2ms, Support static friction and Kinetic COF simultaneous measurement, full digitalization system to ensure accurate and stable testing.
