The equipment tests the initial Tack by short contact between steel ball and adhesive tape sample at a small pressure, adjustable tilt angle 0~ 60 °, rolling ball range 1/32 inch to 1 inch, suitable for a variety of material adhesion evaluation.
Using imported Sensor and motor, Measurement range 0~ 200N, accuracy less than +/- 1%, can store 20 sets of data and automatically print reports, support a variety of substrate replacement.
Measurement range 0~ 500N, accuracy less than +/- 1%, can store 20 sets of results and print reports, humanized fixture supports a variety of substrates.
Sensor and motor imported, Measurement range 0~ 300N, accuracy less than +/- 1%, can store 20 sets of data and automatically calculate the maximum, minimum, average, support a variety of substrate testing.
Using imported Sensor and motor, Measurement range 0~ 50N, accuracy less than +/- 1%, can store 20 test results and print reports, humanized fixture supports changing substrate.
Adopting the principle of the inclined rolling ball method, the adhesion is measured by the short contact between the steel ball and the sample, the adjustment range of the tilt angle is 0-60 °, and the rolling ball of 1/32 to 1 inch is supported. The width of the test area is 80mm.
Adopting the test principle of inclined rolling ball method, the tilt angle adjustment range is 0~ 40 °, equipped with 32 GCr15 bearing steel balls, and the shape tolerance accuracy exceeds GB/T308 level 40 to achieve accurate initial Tack evaluation.
Measurement range 0~ 100N, accuracy less than +/- 1%, can store 20 sets of data and print reports, humanized fixture supports a variety of substrates.
Sensor and motor imported, Measurement range 0~ 100N, accuracy less than +/- 1%, Test speed 300mm/min, can record the maximum tension and failure mode.
Adjustable tilt angle 0~ 40 °, the steel ball meets the standard of GB/T308 grade 40 or above, which is convenient for angle and position adjustment.
Tack is good and non-degumming, adhesion reaches 7.6 N/cm, mass performance is stable, suitable for cross-cut adhesion testing, to ensure accurate film integrity assessment.
The adhesion was measured by the circular trace method, the drawing diaMeter was 0~ 10.5mm, and the Working Travel ≥ 80mm. The integrity of the paint film was evaluated by seven grades, and the operation was simple and conformed to the GB/T1720 standard.
Made of stainless steel, the cutter tooth spacing is 1-3mm, the cut mark length is 35mm, and the coating is cut through the grid pattern, and the adhesion effect is evaluated according to the six-level classification, which is suitable for a variety of surface tests.
The paint film adhesion was measured by the circular trace method, the drawing diaMeter was 0-10.5 mm, and the Working Travel was 80mm. The integrity of the paint film was evaluated according to seven grades, and the operation was simple and reliable.
Hydraulic system measurement coating adhesion, accuracy control within +/- 1% full scale, optional 10mm to 50mm more than the kit size, self-positioning characteristics to ensure smooth rough surface measurement results accurate and reliable.
