The printing pressure can be adjusted accurately according to the thickness of the material, and the printing speed can be adjusted. It provides 4 primary color areas and 4 light color areas to ensure that the pattern is clear and tidy.
Adopt servo electric printing pressure system, printing pressure 0-4mm automatic adjustment, printing speed 0-100 Meters can be set, support low accuracy overprint, simulate Gravure Printing drawdown blade Installation method, easy to detect inks.
Using thermal printing technology, it is designed for use with testing instruments. It can directly connect the color difference Meter and Glossmeter to achieve real-time output of measurement data and report generation.
Adopt 45/0 illumination light receiving system, 8mm measurement aperture, support single and average Measurement mode, Repeatability Standard Deviation ≤ E * within 0.1, can carry out color difference contrast analysis and color quality control.
Using electric pressure system, the printing pressure is adjustable from 0 to 2mm, the speed range is 0 to 80 Meters, low accuracy overprinting is supported, and the computer program control operation is stable.
Measurement range 3μg to 150mg, quick results in one minute, automatic electrolysis current control and thermal printing function.
Driven by numerical control motor, swirl/spin accuracy of 0.1 degrees, support multi-color inks Hue, concentration detection, can anticipate dry and wet ink color change and Abrasion Resistance, 5-10 minutes rapid color development, significantly reduce inks waste.
Dual Light spectrum analysis technology, Wavelength range 360~ 780nm, Support SCI + SCE simultaneous fast measurement, Automatic calibration and Temperature Humidity Compensation to ensure High Accuracy and Stability.
Automatic ink running stability, ink time and speed can be set, printing pressure 0~ 2mm adjustable, provide low, medium and high three printing speed, each time can be proofed 4 colors to facilitate Color contrast.
Adopting ceramic roller synchronous inking technology, the pressure can be adjusted by +/- 2mm, and the material proofing with a thickness of 0.01~ 2mm is supported to achieve accurate repRoduction of solid color and Dot patterns.
The equipment supports 0-2MM pressure adjustment, providing three-speed printing speed (10/15/20 rpm) and uniform ink speed (650/800/1000rpm), which can imprint 2.5mm thick paper and 1mm plastic film to achieve precise uniform ink and stable operation.
Imported aluminum surface reflector and uniform light cover, good light uniformity, CRI ≥ 95, Color temperature 6500K, can open the design for easy replacement of lamps, behind the hook and load-bearing steel chain for easy hanging.
Using CRI = 98 high color rendering index Illuminant, with Illuminant Timer, all metal structure, inclined table design, uniform lighting, suitable for reflection manuscript observation.
With Φ 4mm and Φ 8mm dual measurement caliber, Repeatability Delta E * ab < 0.06, can store 100 sets of master standards, Measurement time only 0.5 seconds, support sub-color difference display and Color bias analysis function.
The printing speed is 0~ 260m/min, the accuracy is less than 0.5, which supports data management and characteristic detection, and can reduce the number of proofing and material waste.
