Overview
The YIHENG microbial incubator model DHP-9011B is a device specially designed for microbial fostering. It uses a mirrored stainless steel liner for easy cleaning, and the natural convection cycle is noiseless and avoids sample volatilization. The box door is equipped with an observation window for easy observation of the experimental process. It is equipped with a fuzzy PID controller for precise temperature control and timing function. Optional independent temperature limit alarm system and UV sterilization system are available to enhance safety and anti-contamination ability.
Features
1. Mirror stainless steel liner, easy to clean the studio.
2. Adopt natural convection cycle mode, no noise, avoid sample volatilization during the test.
3. The box door is equipped with an observation window to facilitate the observation of the experimental process in the box.
4. Fuzzy PID controller, with accurate temperature control and small fluctuations, with timing function, the maximum time setting value is 99 hours and 59 minutes.
5. Optional independent temperature limit alarm system, exceeding the limit temperature will automatically interrupt, ensuring the safe operation of the experiment without accidents.
6. Optional multi-segment LCD programmable controller, a variety of parameters one-screen display, menu Operating interface, simplify the complex test process, to achieve automatic control and operation.
7. Optional ultraviolet sterilization system, regularly disinfect the inside of the box, effectively kill the floating bacteria in the circulating air, and prevent pollution during cell fostering.
Principle
The incubator achieves uniform temperature distribution in the box through natural convection cycle, without noise and avoiding sample volatilization. The fuzzy PID controller is used to precisely adjust the temperature, with low Fluctuation, and an optional multi-stage programmable controller can automatically set and program parameters such as temperature, time and heating rate. It supports layer control and preset functions. The optional UV sterilization system disinfects the inside of the box through ultraviolet irradiation, effectively preventing microbial contamination.
Applications
Microbial foster, cell foster, laboratory research
Steps
Connect the power supply and ensure that the voltage is AC 220V 50Hz.
2. Open the box door and place the sample on the shelf.
3. Close the box door and set the required temperature, time and other parameters through the LCD controller.
4. Start the equipment, observe the Temperature Stability and experimental process.
5. After the experiment, turn off the power and clean the liner.
Notice
• Ensure that the Working Ambient Temperature is within the range of + 5~ 35 ° C.
• Power supply voltage check before use meets AC 220V 50Hz requirements.
• Avoid operating the equipment under conditions of over-temperature or excessive temperature fluctuations.
• Regularly clean the mirror stainless steel liner to maintain hygiene.
• If you need to use an independent temperature limit alarm system or an ultraviolet sterilization system, please choose in advance.
• Pay attention to the observation window during operation to avoid frequent switching affecting Temperature Stability.
