Overview
LABO Compression Tester (Model 17051 (1)) is an independently developed test system with a high intelligence system architecture to fully automate the test process without manual intervention, reduce human measurement errors and improve test efficiency. The test data can be directly printed or uploaded to the Labo-DMS experimental data management system through WIFI and RS232. The Touchscreen interface makes test switching more convenient, and supports ten test methods to switch arbitrarily on the main screen.
Features
1. High intelligence system architecture to achieve fully automated detection process without manual intervention, reducing human measurement errors and improving test efficiency.
2. Operating interface with high definition (8-inch Touchscreen), supports ten test methods to switch arbitrarily on the main screen.
3. The test data can be directly printed or uploaded to the Labo-DMS experimental data management system through WIFI and RS232.
4. Labo-DMS system supports data processing, test report editing (generating Word format) and analysis report generation (including sampling failure rate, Fluctuation analysis, etc.).
5. Using American Vishay High Accuracy Sensor to ensure Measurement accuracy.
6. High Reliability, through the index verification before leaving the factory to ensure the reliability, stability and safety of the instrument.
7. With test starting position memory and automatic reset function.
Principle
The specimen is pressed by the upper and lower pressure plates, and the pressure continues to increase, and the final specimen is crushed, and the maximum pressure applied is the strength of the specimen. The design of the compression tester mainly meets the requirements of paper, Cardboard, Corrugated Board, buffer material and other test standards.
Applications
Paper, Cardboard, Corrugated Board, Cushioning Material
Steps
1. Select the test range: Measured value is less than 50N recommended (10-1000N); greater than 50N is selected (50-5000N).
2. Switch between ten test methods on the main screen.
3. Start the test through the Touchscreen interface.
4. After the test is completed, the data can be directly printed or uploaded to the Labo-DMS system via WIFI or RS232.
Notice
- Select the appropriate range according to the test range: Measured value is less than 50N recommended (10-1000N); greater than 50N is selected (50-5000N).
Make sure the instrument power supply is 110-240V, 50/60 Hz.
- Check the factory verification status of the instrument before use to ensure reliability, stability and safety.
Data transmission optional RS232 or WIFI, software optional experimental data management system.
