Overview
WXQM-8B heavy-duty horizontal planetary Ball mill adopts a double-disc support bracket structure at both ends, which effectively improves the stability and load resistance of the equipment, and breaks through the limitation that the light horizontal planetary Ball mill is only suitable for light loads. The equipment is mainly suitable for users' pilot or small batch ground production.
Features
1. Adopt double-disc support bracket structure at both ends, with strong equipment stability and load resistance.
2. Suitable for pilot or small batch ground production.
3. Two or four ball milling tanks can be operated simultaneously.
4. Adopting frequency conversion stepless speed regulation, the speed can be adjusted in a wide range (revolution 35~ 290rpm, rotation 70~ 580rpm).
5. The running time can be set (total time 1-9999min, positive and negative alternation time 1~ 999min), with a high degree of automation.
6. The maximum processing capacity can reach 8L, and the loading capacity is flexible (two-thirds of the volume of the ball mill tank).
7. The discharge particle size is fine, the minimum can reach 0.1μm.
Principle
The equipment is a horizontal planetary Ball mill, which drives the ball mill tank to perform planetary motion through gear transmission, that is, the ball mill tank rotates while rotating around the spindle. This compound motion causes the grinding ball to generate strong impact, friction and shear force, so as to achieve fine grinding of the material. The equipment adopts frequency conversion speed control speed, and can be set to alternate operation to optimize the grinding effect.
Applications
Geology, Minerals, Metallurgy, Electronics, Building Materials, Pottery and porcelain, Chemical Industry, Light Industry, Environmental Protection, Electronic Pottery and porcelain, Structural Pottery and porcelain, Magnetic Materials, Lithium Cobalt Oxide, Lithium Manganese Oxide, Catalyst, Phosphor, Long Afterglow Luminescent Powder, Rare Earth Polishing Powder, Electronic Glass Powder, Fuel Cell, Zinc Oxidation Varistor, Piezoelectric Pottery and porcelain, Nanomaterials, Wafer Pottery and porcelain Capacitors, MLCC, Thermistors (PTC, NTC), ZnO Varistors, Dielectric Pottery and porcelain, aluminum oxide Pottery and porcelain, Zirconia Pottery and porcelain, Phosphor, Zinc oxidation powder, cobalt oxide powder, Ni-Zn ferrite, Mn-Zn ferrite
Steps
1. Select the appropriate ball milling tank (specification 0.5~ 5L) and grinding ball according to the material characteristics.
2. Load the material and the grinding ball into the ball mill tank, and the loading amount does not exceed two-thirds of the volume of the ball mill tank.
3. Install and fix the ball mill tank on the equipment station (up to 4 can be installed simultaneously).
4. Turn on the 220V-50HZ power supply and turn on the device power supply.
5. Set the required revolution and rotation speed through the frequency converter (revolution 35~ 290rpm, rotation 70~ 580rpm).
6. Set the total running time (1-9999 minutes) and the alternating running time (1-999 minutes).
7. Start the equipment and start the grinding process.
8. After the operation, the equipment automatically stops, takes out the ball mill tank and separates the material from the grinding ball.
Notice
• Feed particle size must meet the requirements: soil material ≤ 10mm, Miscellaneous material ≤ 3mm.
• The sample loading shall not exceed two-thirds of the volume of the ball milling tank to ensure the grinding effect and equipment safety.
• There is noise when the equipment is running (about 60 +/- 5dB), please use it in a suitable environment.
• The equipment is heavy (370kg), and it is necessary to ensure that the ground is flat and stable during installation.
• According to the material characteristics and process requirements, reasonably select the material of the ball mill tank, the size and ratio of the grinding ball.
• Please check whether the components are firmly installed before running.
• Operate in accordance with electrical safety regulations.
