Overview
WXQM-80B heavy-duty horizontal planetary Ball mill adopts a double-disc support bracket structure at both ends, which effectively improves the stability and load resistance of the equipment, and breaks through the limitations of light-duty horizontal planetary Ball mill. The equipment is mainly suitable for users' pilot or small batch ground production.
Features
1. Adopt double disc support bracket structure at both ends, with strong stability and load resistance.
2. Using high-tech microcomputer chip control, it can run alternately according to the setting program forward and reverse repeatedly (0-999min) and forward, pause, reverse, pause, forward (0-999min) alternately, suitable for the need to chill down or intermittent operation needs.
3. Dry grinding, wet grinding, optional vacuum filled inert gas grinding, optional low temperature grinding.
4. Equipped with a three-phase motor variable frequency controller and an electronic monitoring device with power display, it can achieve stepless speed regulation.
5. Maximum Continuous Operating Time up to 48 hours.
Principle
The WXQM-80B heavy-duty horizontal planetary Ball mill adopts the principle of planetary motion. The grinding tank rotates under the driving of the male turntable (revolution speed 35-193rpm), and the tank itself rotates (rotation speed 50-290rpm). This compound motion causes strong impact, friction and shear force between the grinding ball and the material, resulting in efficient and fine grinding effects.
Applications
Geology, Minerals, Metallurgy, Electronics, Building Materials, Pottery and porcelain, Chemical Industry, Light Industry, Environmental Protection, Electronic Pottery and porcelain, Structural Pottery and porcelain, Magnetic Materials, Lithium Cobalt Oxide, Lithium Manganese Oxide, Catalyst, Phosphor, Long Afterglow Luminescent Powder, Rare Earth Polishing Powder, Electronic Glass Powder, Fuel Cell, Zinc Oxidation Varistor, Piezoelectric Pottery and porcelain, Nanomaterials, Wafer Pottery and porcelain Capacitors, MLCC, Thermistors (PTC, NTC), ZnO Varistors, Dielectric Pottery and porcelain, aluminum oxide Pottery and porcelain, Zirconia Pottery and porcelain, Phosphor, Zinc oxidation powder, cobalt oxide powder, Ni-Zn ferrite, Mn-Zn ferrite and other products
Standards
The information does not mention
Steps
1. Select the dry grinding or wet grinding mode according to the material characteristics, and install the corresponding grinding tank.
2. Load the material and grinding ball into the grinding tank to ensure that the loading amount meets the requirements.
3. Set the grinding program through the microcomputer controller, including running time (1-3600min), forward and reverse alternating cycle (1-999min) and running mode (continuous or intermittent).
4. Start the device and set the required revolution and rotation speed through the frequency conversion controller.
5. During the operation of the equipment, the operating status can be observed through the power display electronic monitoring device.
6. After the grinding is completed, the equipment stops according to the set program, takes out the grinding tank and collects the material.
Notice
* Feed particle size must meet the requirements: soil material ≤ 10mm, Miscellaneous material ≤ 3mm.
The equipment voltage is 380V AC, and it is necessary to ensure that the power supply matches.
* The maximum Continuous Operating Time of the equipment is 48 hours, and it is necessary to pay attention to monitoring when running for a long time.
* According to ground requirements, you can choose to configure vacuum filled with inert gas or low temperature grinding accessories.
* The equipment has a forward and reverse alternation and pause function, which is suitable for processes that need to be chilled down or run intermittently.
