Overview
The "DECO-PBM-AD-10L" omni-directional planetary Ball mill is a laboratory powder system sample equipment produced by DECO, which can make the material achieve ultra-effective three-dimensional full grinding, and can also be used for sample crushing, mixing and homogenization processes. The equipment combines the characteristics of vertical and horizontal planetary Ball mills. Through the 360 ° tumbling form of the planetary disc and ball mill tank, the crushing effect and discharge uniformity are significantly improved, and the efficiency and discharge mass are improved.
Features
1. Strong, fast and comprehensive grinding, can achieve High Accuracy and highly consistent discharge effect;
2. Fine grinding, no pollution, a wide range of materials suitable for grinding;
3. Rotation speed, time and other ground data control can ensure the sample ground Repeatability and conformity;
4. It can control the rolling speed of the planetary disk and improve the effect of grinding;
5. Configure a variety of ball milling tanks of different materials to grind at the same time to improve the diversity of grinding samples;
6. Support dry grinding, wet grinding, vacuum/pressurized grinding, inert gas grinding a variety of grinding methods;
7. The grinding room and control room are equipped with highly ventilated heat dissipation;
8. Control system can be controlled, convenient parameter setting, diverse functions, intuitive digital display, simple operation, one-piece operation and safe use;
9. Power-off protection function, automatic storage of ground data;
10. Standardized production process, exquisite craftsmanship, exquisite material selection, environmentally friendly and energy-saving, with a good service life;
11. Ball mill and ball mill tank use method is simple;
12. Maintenance and overhaul are simple and convenient.
Principle
In the planetary ball mill, the four ball mill tanks placed on the planetary disk also perform reverse high-speed swirl/spin under the high-speed swirl/spin of the planetary disk. At the same time, the planetary disk and the ball mill tank as a whole are rolled 360 ° under the power of the motor. In this process of continuous change of orientation, more intense and uniform friction and impact energy are generated between the material and the ground ball, so that the material in the ball mill tank can be fully crushed, mixed and homogenized.
Applications
Pharmaceuticals, Food, Chemicals, Synthetic Materials, Electronics, Engineering, Metallurgy, Glass, Ceramics, Biology
Steps
1. Set ground parameters, including running time, interval time, Rotation speed, etc.;
2. The material and grinding ball into the ball mill tank;
3. Start the device and select the function mode (e.g. run, pause, reverse run, etc.);
4. Monitor the grinding process to ensure the normal operation of the equipment;
5. After the grinding is completed, take out the sample for subsequent processing.
Notice
• Maximum feed size: Soil material ≤ 10mm, Miscellaneous material ≤ 3mm;
• Minimum discharge particle size: 0.1μm;
• Processing capacity: 10L;
• Power supply voltage: 380V, Frequency: 50Hz, single-phase power connector;
• Protection Rating: IP53
• Check the integrity of the equipment before use to ensure safe operation.
• Regular maintenance to extend the service life of the equipment.
