Overview
MP-2B type three-speed Metallographic polish-grinding machine has an independently controlled dual-disc system for grinding and polishing, the fuselage is made of thick plate, which is sturdy, stable and durable; the motor noise is low, the grinding disc rotates smoothly; the cabinet structure is adopted, which can store all kinds of consumables and samples, which is convenient to use; equipped with a chilled down water pipe, which can adjust the swirl/spin direction for wet grinding; only need to replace the sandpaper and throw cloth when using, it can complete the coarse grinding, fine grinding and polishing of various samples. It is a satisfactory metallographic sample preparation equipment in the laboratory.
Features
1. Separately controlled dual disc system for grinding and polishing
2. The fuselage is made of thick plate, which is sturdy, stable and durable
3. Low motor noise and smooth grinding disc rotation
4. Adopt cabinet structure, can store all kinds of consumables, samples, easy to use
5. Equipped with chilled down water pipe, can adjust swirl/spin direction for wet grinding
6. Only by replacing the sandpaper and polishing cloth, various processes such as rough grinding, fine grinding and polishing of various samples can be completed
Principle
The equipment is powered by a motor to swirl/spin the grinding plate, equipped with a chilled down water pipe for wet grinding, and the user completes the coarse grinding, fine grinding and polishing of the sample by changing the sandpaper and the cloth.
Applications
Metallographic sample preparation, laboratory
Steps
1. Choose grinding or polishing disc as needed
2. Install the corresponding sandpaper or cloth
3. Adjust swirl/spin direction for wet grinding (if necessary)
4. Start the equipment for grinding and polishing operation
5. After completing the process, replace the consumables for the next process
Notice
- Make sure the power supply is 380V, 50Hz, three-phase four-wire before use
- Pay attention to the swirling/spinning direction of the grinding wheel when operating
- Regularly check whether the chilled down water pipe is normal
- Make sure the equipment has stopped running when replacing sandpaper or cloth
- Keep the equipment clean and avoid debris from entering
