Overview
YUZHOU MPJ-35 metallographic sample grinding machine is used in the preparation process of metallographic samples to smooth the surface of rough and uneven samples after cutting or unprocessed, so as to improve the prepative mass and ergonomics. The equipment is suitable for wet grinding, dry grinding, grinding and other processes of the sample. The upper half of the machine is made of stainless steel material. Appearance is novel and durable. It is equipped with diamond sanding needles, stainless steel settling filtrate drawers and water supply systems. It has the advantages of convenient operation, safety and reliability, and easy maintenance. It is suitable for grinding of various materials.
Features
1. The upper part of the whole machine is made of stainless steel material, Appearance is novel and durable
2. Equipped with diamond sanding needles, which can flatten the surface of abrasive wheels and improve the utilization rate of abrasive wheels
3. Stainless steel settling filtrate the drawer to prevent clogging of grinding materials and facilitate cleaning
4. abrasive wheels stepless speed regulation, equipped with water supply system
5. Easy to operate, safe and reliable, easy to maintain
Principle
The device grinds the surface of the sample by abrasive wheels swirl/spin, the abrasive wheels Rotation speed can be adjusted steplessly (500~ 1450 rpm), equipped with a water supply system to support wet grinding operation, diamond sanding needles are used to trim the surface of abrasive wheels, stainless steel settling filtrate drawer collects abrasive materials to achieve efficient and flat sample surface preparation.
Applications
Metallographic specimen preparation, grinding of various materials
Steps
1. Place the specimen on abrasive wheels
2. Select the wet or dry grinding mode as needed, and adjust the abrasive wheels Rotation speed
3. Start the equipment for grinding operation
4. Use diamond sanding needles to regularly trim the surface of abrasive wheels
5. Clean stainless steel settling filtrate drawer grinding
Notice
• Make sure the power supply is 380V, 50Hz, 10A, three-phase four-wire before operation
• Regularly check the condition of abrasive wheels and use diamond sanding needles to keep them flat
• Timely settling filtrate drawers to prevent clogging
• Pay attention to safe operation to avoid high-speed swirling/spinning parts hurting people
• Disconnect the power supply during maintenance
