Overview
Japan OSP stainless steel brush S-16 is designed for laboratory cleaning bar and production anilox roller cleaning. The wire brush is made of 0.06mm stainless steel wire, the bristle length is 16mm, the bristle part is 12mm wide and 75mm long, and the base is a wooden structure.
Features
1. The wire diameter is only 0.06mm, which is thinner than the common 0.07mm on the market, and the cleaning effect is more effective
2. The bristles are super soft and clean without damaging the roller surface
3. Made in Japan, each piece is handmade by experienced craftsmen
Principle
The surface of the Anilox Roller and Mayer Rods is scrubbed in circular motion with the ultra-fine stainless steel bristles combined with the cleaning fluid to effectively remove inks and blockages while protecting the surface of the instrument from damage.
Applications
Production machine anilox roller cleaning, laboratory wire-wound drawdown bar cleaning
Steps
1. Rinse Mayer Rods surface inks with water after shutdown
2. Spreader cleaning solution evenly on the surface of the anilox roller, wait for ten minutes and then brush with a wire brush in circular motion for 3-5 minutes, and let the foam stay for 3-5 minutes after brushing
3. Rinse the cleaning solution thoroughly with water
4. When the blockage is serious, the residence time of the cleaning liquid and the brushing time can be extended, or the above steps can be repeability
Notice
• After cleaning, make sure that the cleaning liquid is completely rinsed and does not remain
• When the blockage is serious, the cleaning time and repeability cleaning steps can be appropriately extended
• Pay attention to keep circular motion when using
