Overview
LC-JSY-1GW high temperature thermostatic metal bath is a new product controlled by microcomputer, which can be widely used in sample preservation and reaction, DNA amplification and predenaturation of Electrophoresis, serum coagulation, etc. It adopts metal module design to protect samples from contamination.
Features
1. Temperature and time liquid crystal display;
2. Display the set temperature and instant temperature at the same time;
3. The temperature control time can be set.
4. Programmable multi-point temperature time setting;
5. The use of metal modules allows samples to be protected from contamination.
6. Metal modules can be easily replaced for easy cleaning and disinfection.
7. Temperature deviation calibrating;
8. The buzzer alarm prompt after the temperature control time is over.
Principle
The product drives stainless steel heating pipes or semiconductor heating elements to precisely heat metal modules through a microcomputer Control system, and uses temperature sensors to monitor the module temperature in real time, and achieves thermostatic control through feedback control. Users can set the target temperature, time and multi-point programs, and the equipment runs according to the settings and alarms after the end.
Applications
Sample preservation and reaction, DNA amplification and predenaturation of Electrophoresis, serum coagulation
Steps
1. Turn on the power supply;
2. Set the required temperature, time or multi-point program through the control panel;
3. Put the sample into the corresponding hole of the metal module;
4. Start the device and start running;
5. After the operation, the device beeps an alarm prompt to take out the sample.
Notice
• Make sure the device is used at Rated voltage.
• Do not touch the metal module directly at high temperature to prevent burns.
• Before cleaning or sterilizing metal modules, make sure the equipment is powered off and chilled down.
• When replacing the module, please handle it with care to avoid damaging the interface.
• Do not cover the ventilator when the device is running.
• Use a fuse that meets the specifications (250V 4A to 5 × 20).
