Overview
HUXI HB-40B corrosion-resistant diaphragm pump is a two-stage pump with a gas medium. All parts in contact with the gas are made of polytetrafluoroethylene (PTFE) material, which has a high degree of corrosion resistance and a wide range of applications. It can completely replace water circulation pumps and is suitable for the treatment of corrosive gases in chemical, petrochemical and other industries.
Features
1. Strong chemical corrosion resistance: Corrosion-resistant Vacuumpump uses a special diaphragm and pump head design to ensure that the parts in contact with the gas are imported PTFE materials, which can resist most corrosive gases; at the same time, the electrical switch and shell are also anti-corrosion treatment, which completely solves the problem of chemical corrosion resistance of Vacuumpump.
2. Pollution-free, maintenance-free: diaphragm Vacuumpump can achieve complete recovery of solvents, eliminate the pollution of toxic and harmful organic solvents to the environment and the harm to the health of the operator and nearby personnel; diaphragm pump is a dry pump without water and oil, the user does not need regular cleaning, pipe changing, water changing and other maintenance work, to achieve 100% maintenance-free.
3. Low noise, low vibration: Corrosion-resistant Vacuumpump adopts motor direct-drive power transmission, no intermediate transmission parts, and the characteristics of low stroke and low noise of the diaphragm, so the product noise can be kept below 70dB.
4. Overheating protection: Each product is equipped with a temperature protection switch, when the internal temperature of the body is too high, it will automatically stop, and then start by itself after the temperature is cooled down to ensure the stability and safety of the system.
Principle
The corrosion-resistant diaphragm pump is a two-stage pump with a gas medium. It adopts direct-drive power transmission with no intermediate transmission parts, and realizes vacuum extraction through the low stroke of the diaphragm.
Applications
Chemical, petrochemical and other industries for the treatment of corrosive gases, oil filtration, vacuum distillation, swirl/spin evaporation, vacuum condensing, centrifugal condensing, solid extraction
Steps
1. Connect the power supply: use a 220V/50Hz power supply.
2. Connection interface: Use the 10mm interface to connect the system.
3. Start the pump: Turn on the power switch and the pump starts to work.
4. Monitor operation: Observe the vacuum gauge and temperature to ensure that it is within the allowable range (Vacuum Level 6-8mbar, temperature 5 ° C to 40 ° C).
5. Downtime: Turn off the power after the work is completed.
Notice
• Power frequency is 220V/50Hz.
• Medium and Ambient Temperature should be kept in the range of 5 ℃~ 40 ℃.
• environment relative humidity should be less than 80%.
• The pump will automatically stop when it overheats, and it needs to start by itself after chilling down.
• Avoid use under conditions exceeding the maximum operating pressure by 1 bar.
• Regularly check the running status of the pump to ensure that there is no abnormal noise or vibration.
