Overview
FR-1240-80A Constant Temperature and Humidity Incubator is a FARUI brand product, which can be used for bacterial foster, breeding, fermentation and Miscellaneous thermostatic experiments and foster in scientific research and industrial production departments such as industrial production, biochemistry and agricultural science. The equipment adopts scientific air duct design and exquisite production technology, and has non-standard production ability to ensure that users get suitable drying equipment. It adopts large LCD screen display microcomputer intelligent adjustment technology for temperature control, with automatic display of measured temperature and set temperature at the same time, PID adjustment, thermostatic timing and self-tuning functions, high temperature control accuracy, strong anti-interference ability and easy operation. The heating principle adopts wind circulation to make the temperature distribution in the box uniform and rise smoothly; the liner is brushed stainless steel, which is easy to clean, and the resting board can be arbitrarily set and adjusted in height; the back of the box is provided with a vent hole, and the bottom is provided with a vent hole, which is convenient for the discharge of volatile gases from experimental items.
Features
1. The outer box is Cold rolled steel plate, the surface adopts electrostatic spraying process, the liner is stainless steel, the insulation layer is formed by polyester foam, and the light-transmitting window adopts double-decked hollow Glass to ensure thermal insulation performance (low temperature incubator and BOD require stainless light incubator without glass window), the box body has cold and hot air flow ducts to make the gas circulation smooth and temperature Balanced.
2. The system adopts "zero-crossing" touchless point switching circuit technology to realize pulse width adjustment heating and cooling, and the temperature control fluctuation range is less than 0.5 ° C, and the internal unevenness is about 1.0 ° C.
3, using microprocessor control, with monitoring, temperature control and protection functions, the box lighting is easy to observe the foster, stainless steel liner is not easy to corrode.
Principle
The device uses microcomputer intelligent adjustment technology for temperature control, with PID adjustment and self-tuning functions, heating through the principle of air circulation, so that the temperature distribution in the box is more uniform and the rise is more stable. The system uses "zero-crossing" touchless switch circuit technology to realize pulse width adjustment heating and cooling to ensure high temperature control accuracy.
Applications
Industrial production, biochemistry, agricultural sciences
Steps
1. Before use, place the ultrasonic Nebulizer next to the machine, add water, connect the gasification pipe, and plug the ultrasonic Nebulizer power cord into the three-wire socket behind the right side of the box.
2. Stop humidifying when the machine is heated.
Notice
• When using the humidifier, you should pay attention to adding water in time, and add water once every 1-2 days according to the humidity requirements to prevent damage. When adding water, remove the humidifier power plug, remove the water storage tank, turn it up and unscrew the water sealing port counterclockwise. After adding water, tighten the sealing port, put it on the humidifier, and press the humidifier power supply.
• After the equipment lands, if the ground is uneven, it should be leveled.
The general motion of the equipment should be moved in parallel, and the inclination in either direction should be less than 45 degrees.
• During normal operation of this equipment, the placement of the contents in the box should not affect the air circulation to ensure uniform temperature in the box.
• The wall liner and equipment surface should be wiped frequently to keep clean.
If it is not used for a long time, the power cord should be removed to prevent the equipment from being charged and injuring people, and it should be run regularly (usually in the first quarter) for 2-3 days according to the conditions of use to drive away moisture from the electrical components and avoid damage to the relevant devices.
