Overview
The SB-800DTD Ultrasonic Cleaner is a device produced by JINGQI. It is equipped with a large-screen LCD display that can display the temperature in the tank in real time, set the ultrasonic cleaning time and count down. The device features a stainless steel case and a muted cover. It has functions such as power and temperature adjustment, power-off memory of working parameters, and more.
Features
1. Equipped with a large-screen LCD monitor, it can display the actual temperature in the cleaning tank in real time.
2. Parameter selection through the monitor menu is intuitive to operate.
3. The temperature setting range is from room temperature to 80 ° C to meet different cleaning requirements.
4. Ultrasonic Power can be continuously adjusted in the range of 0% -100%.
5. Optional stainless steel mesh basket and sound lowering cover to improve the convenience of use and mute effect.
6. The LCD screen can display the set ultrasonic cleaning time and work countdown.
7. The inner and outer shells of the instrument and the sound lowering cover are made of high-quality stainless steel, which is sturdy and durable.
8. The operation program is controlled by microcontroller software, with a high degree of intelligence.
9. The LCD screen shows the degassing function and is adjustable.
10. With power-off memory function of working parameters, no need for repeability setting after restart.
Principle
The Ultrasonic Cleaner uses a high-frequency electrical signal (Frequency is 40KHz) to drive the transducer to generate ultrasonic waves. When ultrasonic waves propagate in the cleaning liquid, a large number of tiny bubbles (cavitation effect) are generated. The impact force generated by these bubbles when they break can penetrate into the fine gaps on the surface of the article, thereby disbonding and removing impurities such as dirt and grease attached to them. At the same time, the equipment is equipped with a heating function to enhance the cleaning effect by raising the temperature of the cleaning liquid.
Applications
Laboratory utensils cleaning, Hardware parts degreasing and decontamination, Electronic components cleaning, Jewelry cleaning, Optical inspection lens treatment, Medical equipment pretreatment, Auto parts cleaning, Precision instrument maintenance
Standards
The data did not mention specific compliance criteria.
Steps
1. Add an appropriate amount of cleaning liquid to the cleaning tank.
2. Put the items to be cleaned into the tank, and the matching net basket can be used.
3. Turn on the power supply and turn on the power switch of the device.
4. Through the menu on the LCD screen, set the required cleaning temperature (room temperature -80 ° C) and ultrasonic cleaning time (1-99 minutes).
5. Set the ultrasonic Power percentage (0% -100%) and degassing function as required.
6. Press the start button, the device starts to heat up and run ultrasonic cleaning, and the screen displays a countdown.
7. After cleaning is completed, the equipment automatically stops and the items are taken out.
8. After use, the cleaning liquid can be drained through the drain valve.
Notice
• Do not start the ultrasonic and heating functions without cleaning liquid in the tank to avoid damage to the equipment.
• The amount of cleaning liquid added should ensure that it can submerge the items to be cleaned, but should not exceed the maximum liquid level marked on the tank body.
• Cleaning items should be properly placed to avoid direct contact with the bottom of the tank. It is recommended to use a net basket.
When setting the temperature, do not exceed the upper limit of 80 ° C.
• When using corrosion or flammable cleaning fluids, special attention should be paid to safety and ensure good ventilation.
• During the operation of the equipment, do not put your hands into the cleaning liquid.
• When not in use for a long time, please empty the cleaning liquid and keep the equipment drying.
• Before performing maintenance, be sure to disconnect the power supply of the equipment.
