Overview
SB-1500DT ultrasonic cleaner is a large-capacity cleaning equipment produced by JINGQI brand. Its inner tank size is 600 * 500 * 300mm, the capacity is 90L, and it uses 28KHz ultrasonic Frequency and 1500W total Power for efficient cleaning. The equipment has heating function, Heating power is 4000W, the temperature can be set from room temperature to 80 ° C, and it is equipped with 1-99 minutes total Working time setting, countdown display, drainage function and power-off memory function.
Features
1. Digital display to set the ultrasonic cleaning time, Working time countdown display.
2. Real-time display of the actual temperature in the cleaning tank, with a temperature setting range from room temperature to 80 ° C.
3. Equipped with a special stainless steel net basket and a flat cover.
4. The instrument's inner and outer casing and sound-lowering cover are made of good stainless steel.
5. The operating procedures of the instrument are based on microcontroller software.
6. With power-off memory function for working parameters.
7.1-99 minutes Total Working time setting.
8. Equipped with drainage function.
Principle
The ultrasonic cleaner uses high-frequency (28KHz) ultrasonic waves to generate cavitation effect in the cleaning liquid, forming countless tiny bubbles and instantly bursting, generating impact force to disbonding stains attached to the surface of the object. At the same time, the device has a built-in heating system, which can heat the cleaning liquid to a set temperature (room temperature to 80 ° C). Through the synergistic effect of thermal energy and mechanical vibration, the cleaning efficiency and effect are improved. The whole working process is controlled by the single-chip microcomputer program to achieve accurate setting and display of time and temperature.
Applications
Industrial parts cleaning, laboratory utensils cleaning, medical apparatus pretreatment, electronic components cleaning, jewelry cleaning, Optical inspection lens cleaning, Hardware tool cleaning, automotive parts cleaning
Standards
The data did not mention specific compliance criteria.
Steps
1. Inject the cleaning liquid into the cleaning tank to the appropriate level.
2. Put the items to be cleaned into a special stainless steel mesh basket and place them in the tank.
3. Cover the bass cover.
4. Set the required cleaning temperature (room temperature to 80 ° C) through the control panel.
5. Set the cleaning time (1-99 minutes) through the control panel.
6. Start the equipment, start heating and ultrasonic cleaning.
7. The countdown of the equipment is over and the cleaning is completed.
8. Take out the net basket and items, and enable the drainage function if you need to drain.
Notice
• Do not activate the ultrasonic and heating functions without cleaning fluid.
The cleaning fluid level should meet the requirements to avoid being too high or too low.
• Please use the special stainless steel net basket matched with the equipment.
• The set temperature must not exceed 80 ° C.
Equipment housing is made of stainless steel, but it is still necessary to avoid impact.
• After cleaning is completed, the cleaning liquid can be emptied using the drainage function as needed.
• The device has a power-off memory function. Please pay attention to check the parameters after re-powering.
