Overview
HZAOC LSO2-600 SO2 corrosion test chamber is suitable for corrosion gas testing of parts, electronic components, protective layers of metal materials and industrial products. The equipment is made of corrosion resistant materials and has precise temperature, Humidity and sulfur dioxide concentration control capabilities.
Features
1. The box is made of 8mm thick PVC reinforced rigid plastic plate, which is resistant to aging, corrosion and easy to clean.
2. The box door adopts 8mm tempered Glass, which is easy to observe, and is equipped with foam silicone sealing strip to prevent gas leakage.
3, the heating system uses titanium alloy heating tube, corrosion resistance, rapid heating, uniform temperature distribution.
4. Control system adopts High Accuracy Digital Temperature Controller, accurate and stable control, with power-off memory function.
5. Sensor adopts corrosion resistant 316 material PT100 test Sensor.
6, the concentration of sulfur dioxide is controlled by the Measurement tube buoy, and the airway adopts corrosion-resistant silicone tube.
7. With multiple protection and fault alarm functions such as over-temperature, low water level, overload, fan overheating, and leakage.
8, the exhaust gas is discharged after the alkali solution is filtrated to reduce environment pollution.
Principle
Flow rate of sulfur dioxide gas is precisely controlled by a Glass Rotor Flow rate meter to adjust the gas concentration in the test chamber. Air Heating mode is used in the box, and the temperature control system precisely controls the temperature and Humidity environment required for the test to simulate corrosion conditions. After the test, the exhaust gas is neutralized filtrated through the alkali solution and discharged.
Applications
Parts, electronic components, protective layers of metal materials, industrial products
Steps
1. Place the sample in the studio.
2. Set the required temperature, Humidity and test time parameters.
3. Control the gas input through the sulfur dioxide Flow rate meter and adjust the gas concentration in the box.
4. Start the equipment and start the corrosion test.
5. During the test, the sample status can be observed through the tempered Glass door.
6. After the test, the equipment automatically or manually starts the waste discharge system to filtrate the exhaust gas and discharge it.
Notice
* Before the equipment runs, ensure that the sealing is good to prevent gas leakage.
* Regularly check the alkali solution filtrating device to ensure effective waste gas treatment.
When operating, please pay attention to the multi-protection system alarm prompt of the equipment and deal with it in a timely manner.
* Use corrosion-resistant sulfur dioxide gas source to ensure gas purity of 99.99%.
* Non-professional personnel should not disassemble or modify the equipment Control system and pneumatic system.
