Overview
HZAOC SC-020 Dust test chamber is mainly used for electrical, electronic, automotive, Motorcycle and Miscellaneous products parts for dust test, effectively simulate the sand dust climate environment. The equipment uses stainless steel liner and spray box, equipped with a new generation of Xinjie PLC integrated machine controller, intuitive and easy to operate.
Features
1. Using large diameter stainless steel centrifugal wind turbine, with dust mixing and drying mechanism, effectively absorb dust.
2. The micro eccentric motor is used to achieve vibration, and the dust shaking effect is better.
3. The bottom of the box funnel is equipped with a dust cleaning discharge port, which is convenient for dust cleaning and replacement.
4. Equipped with bright and clear large observation window and lighting, wide field of vision, easy to observe the dust concentration and dust volume in the box.
5. Adopt matte black three-dimensional control panel, man-machine interface and control switch layout eye-catching, easy to operate and easy to use.
6. The controller adopts Xinjie's new generation of highly integrated PLC all-in-one machine (touch key man-machine interface + PLC), the system is stable and reliable, and the backlight LCD display and man-machine dialogue input method are adopted.
7. The control interface configuration screen is concise and clear.
8. It is equipped with a dust drying heating device, which can be started through the control interface button during the test, drying the dust without affecting the test process, and ensuring that the test data is correct.
9. Equipped with power component anti-overload protection, equipment phase loss and phase sequence protection, the controller has an alarm screen prompt when the protection action is taken.
Principle
The device sucks in dust through a large-diameter stainless steel centrifugal wind wheel, and cooperates with a dust stirring and drying mechanism to ensure that the dust effectively enters the test area. At the same time, the micro-eccentric motor generates vibration, which fully raises the dust and simulates the real dust environment. The controller precisely manages the test process, including dust drying heating, to maintain the required dust concentration and test conditions.
Applications
Dust testing of electrical, electronic, automotive, Motorcycle and Miscellaneous parts
Standards
GB/T 2423.37-06、GB4208-08、GB2423.37-89La、GB7001-86、GB10485-89、GB/T4208-93、GB/T2423.37-89
Steps
1. Perform man-machine dialogue operations in the order indicated on the controller display.
2. During the test, if the dust is found to be humid, the dust drying heating device can be started through the control interface.
3. After the dust is drying, turn off the heating button.
4. After the test, the dust can be cleaned through the discharge port at the bottom of the box.
Notice
• Test dust shall be a drying tale powder capable of passing through a square hole sieve with a sieve of 75 µm and a wire diameter of 50 µm.
• The vacuum system is optional, and it needs to be explained when ordering, and the vacuum pump needs to be equipped by the customer.
• Please pay attention to the alarm screen prompt on the controller when operating, and the equipment is equipped with Safety protection function.
• The dust drying process will not interrupt the test, but the heating function should be turned off in time after the drying is completed.
