Overview
BENTING CDZ-5000ml Electric Mantle is mainly used for laboratory liquid heating in colleges and universities, Petrochemicals, environmental protection and other industries. It uses high temperature resistant and alkali-free fiberglass as insulating material, seals the resistance wire in the insulating layer, and weaves it into a hemispherical internal heating heater. It has the advantages of large heating area, fast heating, good thermal insulation effect, no open flame, and not easy to scratch Glass utensils.
Features
1. Using high temperature non-alkali fiberglass insulation material, resistance wire sealing in the insulating layer, woven into a hemispherical inner heat heater;
2. Large heating area, fast heating, good thermal insulation effect;
3. No open flame, not easy to hurt Glass ware;
4. Adopt professional non-electric shock electronic voltage regulation circuit, with long service life and wide temperature regulation range.
5. With voltage regulation function, the voltage and temperature are controlled by adjusting the knob to achieve the purpose of thermostatic.
Principle
The product uses a professional electronic voltage regulation circuit without electric shock. By turning the knob to adjust the voltage and control the temperature, the indicator light is on or the voltmeter changes accordingly to achieve the purpose of thermostatic. At the beginning, the voltage adjustment should not be too high, and the temperature should be raised slowly to avoid damage to the heater.
Applications
Liquid heating in laboratories in colleges and universities, Petrochemicals, environmental protection and other industries
Steps
1. Heat up slowly, and do not adjust the voltage too high at the beginning.
2. Turn the knob to adjust the voltage control temperature and observe the change of the indicator light or voltmeter.
3. Remain thermostatic after reaching the desired temperature.
Notice
• When using it for the first time, slowly heat up. Turn off the power supply after seeing the raw white smoke. After the smoke is scattered, heat up when powered on, and repeat it several times until it is officially used after power on and smoke-free;
• The sleeve cannot enter flammable, explosive, corrosive liquids or gases;
• Relative working environment humidity does not exceed 85%;
• The product must be grounded, dried and not damp during storage;
• If there is moisture, you should pay attention to induction electricity when using it, do not touch it with your hands, and restore its good insulation performance after drying.
