Overview
DADI 101-5A type thermostatic blower drying oven has a maximum Operating temperature of 250 ° C, suitable for baking, drying, heat treatment and other heating. The product structure is precise, the temperature control is sensitive and accurate, and the operation is simple. It can be used in industry, laboratory or scientific research units. The drying oven Operating temperature can be raised from room temperature to the highest temperature. Operating temperature can be set arbitrarily within this range. After setting, the temperature control system can be automatically thermostatic, and the working room is equipped with a blower, which can promote air mechanical circulation.
Features
1. Adopt a microcomputer intelligent temperature controller for sensitive and accurate temperature control.
2. The working room is equipped with a blower to promote mechanical air circulation.
3. The box door is a double-decked tempered Glass door, which can be observed in the studio without opening the door.
4. With over-temperature alarm safety device.
5. Timer Range, up to 0~ 9999 minutes.
6. Inner Chamber dimensions are large, 1000 * 1000 * 1200mm.
Principle
The drying oven is heated by an electric heater, and the temperature is automatically adjusted by a smart temperature controller. The temperature sensor extends into the studio to sense the temperature, and the temperature control system automatically controls the Heating power (using thyristor output) according to the set value to achieve thermostatic. The working room is equipped with a blower, which can promote the mechanical circulation of air, so that the temperature in the box is uniform.
Applications
Industrial, laboratory, and scientific research units
Steps
1. Place the drying oven in a suitable position to ensure that the power supply voltage matches the rated Operating voltage.
2. Open the box door and place the test product on the shelf of the studio, be careful not to be too dense and overloaded.
3. Close the box door and set the required Operating temperature and timing time through the controller on the panel.
4. Start the equipment, the drying oven starts heating and automatically runs thermostatic.
5. The working room can be observed through the double-decked Glass door.
6. After the work is completed, take out the test product after the equipment is chilled down.
Notice
• This box is non-explosion-proof, do not put in flammable volatile items to avoid explosion.
• The average load of the sample shelf is 45KG/M ². Do not place the sample too tightly and overloaded. Miscellaneous things and samples cannot be placed on the heat dissipation plate to avoid affecting the convection of hot air.
• When using this box, the power supply voltage must match the rated Operating voltage of this box, otherwise it may cause damage to the electronic instruments in the box.
• Do not disassemble the parts arbitrarily, so as not to damage the electrical wiring in the box.
If the box malfunctions, it should be repaired by an electrician who is familiar with electronic equipment.
