Overview
The DADI 202-1A thermostatic blast drying oven has a maximum operating temperature of 250 ° C, which is suitable for baking, drying, heat treatment and other heating. The product has a precise structure, sensitive and accurate temperature control, and is easy to operate. It can be used in industry, laboratories or scientific research units. Operating temperature can be raised from room temperature to the highest temperature, which can be set arbitrarily within this range. After setting, the temperature control system can be automatically thermostatic, and the working room is equipped with a blower, which can promote mechanical air circulation.
Features
1.Double-decked Large Glass Observation Door
2. Microcomputer intelligent temperature controller
3. Thyristor output
4. Over-temperature alarm
Principle
The drying oven is heated by an electric heater, and the temperature is automatically adjusted by a smart temperature controller. A temperature sensor extends into the studio to sense the temperature, and the controller adjusts the heating output according to the difference between the set value and the actual value. A blower is installed in the studio to facilitate mechanical circulation of the air, resulting in a more uniform temperature distribution.
Applications
Industrial, laboratory, and scientific research units
Steps
1. Place the equipment in a stable, well-ventilated position.
2. Connect the power supply that meets the rated Operating voltage.
3. Turn on the power switch.
4. Set the required Operating temperature (RT + 50~ 250 ℃ range) through the microcomputer intelligent temperature controller.
5. Place the items to be handled in the working room, taking care not to overload or overload.
6. Close the double-decked Glass door, the device starts heating and automatically thermostatic.
7. You can check the internal situation through the observation door.
8. After use, turn off the power.
Notice
• This box is non-explosion-proof, do not put in flammable volatile items to avoid explosion.
• The average load of the sample shelf is 45KG/M ². Do not place the sample too tightly and overloaded. Miscellaneous things and samples cannot be placed on the heat dissipation plate to avoid affecting the convection of hot air.
• When using this box, the power supply voltage must match the rated Operating voltage of this box, otherwise it may cause damage to the electronic instruments in the box.
• Do not disassemble the parts arbitrarily, so as not to damage the electrical wiring in the box.
If the box malfunctions, it should be repaired by an electrician who is familiar with electronic equipment.
