Overview
The DADI HH-S1 thermostatic water bath is an electrothermal thermostatic device with stainless steel sink and cover, Cold rolled steel plate spray case, electronic temperature control system and digital display of actual temperature. This product is suitable for distillation, drying, condensing and warming chemical or biological products.
Features
1. Beautiful, corrosion-resistant, stable temperature control, energy-saving and practical, convenient maintenance, long service life
2. Using special electronic temperature control, the actual temperature in the pot is directly displayed digitally
3. The sink and cover are made of stainless steel, and the chassis is carefully sprayed with a good Cold rolled steel plate
Principle
This product heats the water in the water tank through an electric heating element. The temperature control part adopts an integrated circuit Sensor, a single-chip microcomputer, PID and fuzzy control technology to achieve High Accuracy temperature control and ensure that the water temperature is stable within the set range.
Applications
Distillation, drying, condensing, warming chemicals or biological products
Steps
1. Inject water above the Shelf before power on
2. Make sure the heating tube is not exposed to the water
3. Connect 220V AC power supply, use three-hole safety socket and properly ground
4. Set and monitor temperature by thermostat
Notice
• Use 220V AC power supply, the power socket should use a three-hole safety socket, which needs to be properly grounded, and must not connect the grounding wire to the gas pipe
• Before power on, water should be injected into the pot above the Shelf. During use, the heating tube must not be exposed to the water surface, otherwise the heating tube will burn out or even burst or the solder will melt and leak, electric shock, etc
