Overview
DADI HH-S2A (stainless steel cover) thermostatic water bath is a laboratory equipment used for distillation, drying, condensing and warming of chemical or biological products. The product is a double-hole design, the sink and cover are made of stainless steel, and the chassis is sprayed with Cold rolled steel plate. It has the characteristics of beauty, corrosion resistance, stable temperature control, energy saving and practicality.
Features
1, sink and cover are made of stainless steel, corrosion resistance.
2. The chassis is made of high-quality Cold rolled steel plate, which is sturdy and beautiful.
3. Adopt a special electronic temperature control system for stable and reliable temperature control.
4. It is energy-saving and practical, easy to maintain, and has a long service life.
5. Adopt digital display mode, Temperature resolution is high, easy to operate.
Principle
This product heats the water in the sink through a built-in heating pipe, and adopts a temperature controller integrated with Sensor, MCU, PID and fuzzy control technologies for accurate temperature control. The temperature controller monitors the water temperature in real time, and controls the working state of the heating pipe to stabilize the water temperature within the set target Temperature range.
Applications
Distillation, drying, condensing, warming chemicals or biological products
Steps
1. Before use, inject water into the Water bath, and the water level should exceed the Shelf.
2. Plug the power plug into a properly grounded Three hole safety socket.
3. Set the required temperature and Working time parameters through the digital display panel.
4, turn on the power supply, the equipment starts heating and temperature control operation.
Notice
• Safe use of electricity: must use 220V AC power supply, and access Three hole safety socket, and need to be properly grounded, do not connect the ground wire to the gas pipe.
• Water injection requirements: Water must be filled above the Shelf before power on, and the heating pipe must not be exposed to the water during use to prevent burning, bursting, solder melting and leakage or electric shock.
• Operation and maintenance: Please follow the instructions and pay attention to daily maintenance.
