Overview
FENGZHIYUE 55 Dyne pen is an orange model surface tension test tool that can accurately test whether the surface tension of Plastic film, metal, Pottery and porcelain materials reaches the test pen value, help users determine whether the material is suitable for printing, composite or vacuum aluminizing, effectively control mass and reduce tool delays caused by material failure.
Features
1. The water outlet is uniform
2. mass stabilization
Step 3 Test accuracy
4. Cost-effective
Principle
Draw test lines on the surface of the material through Dyne pen to observe whether the ink is evenly spread or cissing, so as to determine whether the surface tension of the material reaches the value marked by the test pen.
Applications
Thin film, metal, Pottery and porcelain all materials surface tension testing
Steps
1. Choose the right Dyne pen
2. Draw test lines evenly on the surface of the material to be tested
3. Observe the spread of ink within 2 seconds
4. If the ink is continuously spread evenly, the surface tension is up to standard; if the cissing into droplets, it is not up to standard
Notice
• Make sure the surface of the material is clean and drying before testing
• Test line drawing should be uniform
• The observation time is controlled within 2 seconds
• Different rod numbers correspond to different tension values, which need to be selected according to material requirements
• Cover the pen cap tightly in time after use to prevent ink evaporation
