Overview
DADI CHD20120 Low Temperature Circulating Bath is a precision thermostatic device controlled by a microcomputer temperature controller. The chassis is made of cold-rolled plate spray, the liner is made of stainless steel, and the foaming agent is used for thermal insulation. It has the characteristics of strong structure and good thermal insulation effect. It is suitable for precision thermostatic experiments in biological, chemical, physical, plant, chemical and other scientific research fields.
Features
1. Using microcomputer temperature controller control, high temperature control accuracy.
2. The chassis is made of good cold-rolled plate spray, and the structure is strong and reliable.
3. The liner is made of good stainless steel, which is durable and easy to clean.
4. The thermal insulation layer is foamed with a foaming agent, and the thermal insulation effect is good.
5. Equipped with a circulating pump, the temperature in the working room can be uniform.
Principle
The equipment is set and controlled by a microcomputer temperature controller. The heating system heats according to the set value, while the Compressor refrigeration system can provide chill down as needed for accurate temperature control. The built-in circulating pump circulates the liquid in the Tank to ensure Temperature uniformity.
Applications
Biological, chemical, physical, plant, chemical and other scientific research
Steps
1. Read the instructions carefully before use.
2. Add the refrigeration solution to the overflow port.
3. Turn on the power switch and set the required temperature on the thermostat.
4. Turn on the circulating pump switch to circulate the liquid, resulting in a more uniform temperature.
5. According to the temperature control accuracy requirements, select the "dual control" or "direct cooling" mode of the refrigeration switch, and refer to the manual to set the relevant parameters of the temperature controller (such as CL, P, CT values or start the self-tuning function).
Notice
• Refrigeration medium is recommended to use distillation water, alcohol, etc. It is strictly forbidden to use sodium chloride and other corrosion solutions.
• When using the pump externally, the horizontal position of the external water bath should be higher than that of this equipment, and the inlet pipe is at the bottom and the outlet pipe is at the upper part. Before use, make sure that there is a certain liquid in the external water bath to prevent the liquid in this equipment from being evacuated and causing damage to the heating pipe.
When using, pay attention to keep it clean and tidy to prevent liquid from splashing into the controller, so as not to cause line failure, damage or leakage.
