Overview
DADI 202-3 electric thermostatic drying oven has a maximum operating temperature of 300 ° C, which is suitable for baking, drying, heat treatment and other heating. The product structure is precise, the temperature control is sensitive and accurate, and the operation is simple. It can be used in industry, laboratories or scientific research units. The drying oven Operating temperature can be raised from room temperature to the highest temperature. Operating temperature can be set arbitrarily within this range. After setting, the temperature control system can be automatically thermostatic, and the working room is equipped with a blower, which can promote air mechanical circulation.
Features
1. Operating temperature up to 300 ℃, Temperature range.
2. The smart temperature controller is used to automatically adjust the temperature, and the temperature control is sensitive and accurate.
3. The working room is equipped with a blower, which promotes the mechanical circulation of air, and the Temperature Uniformity ≤ +/- 3.5%.
4. The box door is a double-decked tempered Glass door, which can be observed in the studio without opening the door.
5. Controllers, electric heaters, and other electrical equipment are all operated on the panel, making it easy to operate.
6. The control room has a side door that can be removed for easy inspection or repair of wiring.
Principle
The drying oven is heated by an electric heater, and the smart temperature controller automatically adjusts the Heating power according to the sensing signal of the temperature sensor to achieve accurate temperature control. A blower is installed in the studio to promote mechanical circulation of air and make the internal temperature of the studio more uniform. Users can arbitrarily set the Operating temperature within the room temperature to the highest Temperature range, and the temperature control system can automatically thermostatic after setting.
Applications
Industrial, laboratory, and scientific research units
Standards
JB/T5520-91、JB/Z339-89
Steps
1. Place the drying oven in a stable and well ventilated position.
2. Confirm that the power supply voltage matches the rated Operating voltage of the box (220V 50Hz) and then turn on the power supply.
3. Turn on the power switch and set the required Operating temperature (RT + 50~ 300 ℃ range) through the intelligent temperature controller.
4. Place the items to be handled in the working room, be careful not to be too dense or overloaded, and do not place items on the heat dissipation board.
5. Close the box door, the device will start heating and automatically thermostatic to the set temperature.
6. Internal conditions can be observed through double-decked tempered Glass doors during work.
7. After the work is completed, turn off the power switch and wait until the temperature in the box drops to a safe range before removing the items.
Notice
• This box is non-explosion-proof, do not put flammable volatile items into the drying oven to avoid explosion.
• The average load of the sample shelf is 45KG/M ². Do not place the sample too tightly and overloaded. At the same time, the sample and Miscellaneous things cannot be placed on the heat dissipation plate to avoid affecting the convection of hot air.
• When using this box, the power supply voltage must match the rated Operating voltage of this box (220V 50Hz), otherwise it may cause damage to the electronic instruments in the box.
• Do not disassemble the parts arbitrarily, so as not to damage the electrical wiring in the box.
If the box malfunctions, it should be repaired by an electrician who is familiar with electronic equipment.
