Overview
The three-hole three-temperature Thermostatic bath DK-10SKA is equipped with three sets of independent water-oil Thermostatic baths, equipped with three corresponding automatic control systems, which can simultaneously set, control and display different temperatures in each set of tanks. This product is suitable for thermostatic experiments and auxiliary heating of 1-3 different temperatures at the same time.
Features
1. Adopt imported microcomputer temperature control, PID adjustment, self-tuning control technology, high temperature control accuracy.
2. Equipped with break-even protection function to prevent the instrument from losing control.
3. With the upper limit over-temperature alarm function, users can set the alarm range by themselves, and alarm immediately if it exceeds the range.
4. The instrument works stably and reliably, making it very convenient to operate.
5. Microcomputer correction temperature measurement deviation, digital display accuracy up to 0.5 ℃.
Principle
The device controls the temperature of three groups of Thermostatic baths through three independent automatic control systems. The system adopts microcomputer temperature control, PID adjustment and self-tuning technology to monitor and adjust the temperature in the tank in real time to achieve and maintain the set target temperature.
Applications
Drying, condensing, agriculture, distillation, chemical reagents, impregnations and biological products, thermostatic fostering, boiling and sterilizing equipment
Steps
1. Turn on the power supply (220V/50Hz).
2. Add an appropriate amount of water or oil medium to the three Thermostatic baths respectively.
3. Set the required temperature through three independent control systems.
4. Start the device, the system will automatically heat and thermostatic to the set value.
5. After the experiment, turn off the power.
Notice
* Power supply voltage is 220V/50Hz before use.
When adding media to the tank, do not exceed the maximum capacity.
* When setting the over-temperature alarm value, please set it reasonably according to the experimental safety requirements.
When the equipment is working, do not touch the heating part and high-temperature medium to prevent burns.
Do not move or tilt the device while it is running.
* Before cleaning the equipment, be sure to disconnect the power supply and wait for the equipment to completely chill down.
