Overview
HORIZON DLS-05 Electronic Tensile Tester is a special equipment for material mechanical performance testing of Plastic film, composite film, etc., which can measure tensile strength, fracture elongation, Modulus of Elasticity, and conduct disbonding, tearing, heat sealing strength and other tests.
Features
1. Operation mode of touch keys, LCD display multiple interfaces in real time
2. Can be pulled off and shut down, peak holding, with overcurrent, overvoltage and overload protection
3. Measurable stretching, heat sealing, disbonding, tearing and other items
4. Can be determined elongation force value, fixed force value to measure elongation, display force value, displacement Linear dispersion
5. Single point speed regulation or stepless speed regulation (1-500mm/min)
60,000 joint adopts cross pin structure, with swing angle limit function to ensure concentricity
7. Control mode closed loop, high control accuracy
Principle
Control mode through the closed-loop equipment accurately applied tensile force, real-time monitoring of force value and displacement changes, can be fixed elongation force value or constant force value measurement elongation operation, and through the liquid crystal display Linear dispersion and test results.
Applications
Plastic film, composite film
Standards
GB/T13022、GB/T8808、GB 1040、GB/T4850、GB/T 16578、QB/T 2358、QB/T 1130
Steps
1. Connect the power supply and turn it on.
2. Select test methods and parameters
3. Install the specimen and hold it
4. Start the test and observe the display interface in real time
5. View results and Linear dispersion after the test is complete
6. Use the microprinter to output data
Notice
• Power supply voltage 220V +/- 10%
• Ensure concentricity when the sample is clamped
• Avoid overloading equipment
• Regularly check the function of the protective device
• Test with standard fixtures
