Overview
HUXI HR-500/20DF High Shear Dispersion Mulser can effectively, quickly and uniformly distribute one or more phases into another continuous phase, especially for materials that are incompatible with each other. The high circumferential speed and high frequency mechanical effect generated by the high-speed swirl/spin of the rotor make the material subject to strong mechanical and hydraulic shear, centrifugal extrusion, liquid layer friction, impact tearing and turbulence in the narrow gap of the stator and rotor, so as to achieve instant uniform and fine dispersion emulsification, and finally obtain stable high-quality products.
Features
1. Processing capacity range is wide, standard Processing capacity is 50-3000ml
2. Speed range up to 8000-28000rpm
3. Maximum processing viscosity up to 3000cp
4. The maximum linear speed of the rotor is 22m/s
5. The working head is made of SS316L, graphite ceramics, FKM and other materials
6. High temperature resistance up to 180 ° C
7. Power Configuration Reasonable, Input Power 500W, Output Power 320W
8. Rotation speed displayed on scale, intuitive operation
Principle
The high circumferential velocity and high-frequency mechanical effects generated by the high-speed swirl/spin of the rotor make the material subject to strong mechanical and hydraulic shearing, centrifugal extrusion, liquid layer friction, impact tearing and turbulence in the narrow gap between the stator and the rotor. Under the combined action of the corresponding mature process and appropriate additives, the immiscible solid phase, liquid phase and gas phase can disperse the emulsification uniformly and finely in an instant, and through high-frequency cycles, stable high-quality products are finally obtained.
Applications
Chemical, pharmaceutical, food, cosmetics, coatings, inks, pesticides, daily chemicals, electronics, new energy, biotechnology, nanomaterials, environmentally friendly water treatment, petroleum, paper, Spinning & weaving, metallurgy, building materials
Steps
1. Select the appropriate gear according to the material characteristics (A-G gear corresponds to 8000-28000rpm Rotation speed)
2. Connect the motor to the working head assembly
3. Add the material to the processing container
4. Start the device and adjust to the desired Rotation speed
5. Decentralized emulsification
6. Turn off the device after processing is complete
7. Clean the working head and container
Notice
• Power supply voltage meets equipment requirements (220V/50-60Hz) before use
• Processing materials shall not exceed the maximum Processing capacity 3000ml
• Material viscosity should not exceed 3000cp
• Operating temperature must not exceed 180 ° C
• Regularly check the abrasion of the working head
• Keep the equipment clean to prevent material residue
• Pay attention to safety during operation and avoid contact with swirling/spinning parts
