Overview
HUXI HX-20T heating type thermostatic mixing bath is an intelligent laboratory equipment that integrates mixing, oscillation and incubate heating functions. It is controlled by a microprocessor and can perform thermostatic oscillation mixing and incubate heating treatment on commonly used consumables such as microtubes, PCR plates, deep well plates and microwell plates.
Features
1. LCD liquid crystal display, using man-machine friendly touch Operating interface.
2. With power-off recovery function, it can automatically resume operation according to the original setting program.
3. The microprocessor controls the temperature, Rotation speed and time, the temperature control is linear, the oscillation Rotation speed is accurate and the fluctuation is small.
4. DC brushless motor drive, long life and maintenance-free.
5. Metal modules are used to protect samples from contamination, and the modules are easy to replace, clean, and disinfect.
6. With timing function, 0~ 100 hours to set the foster time arbitrarily.
7. Adjustment of temperature deviation and built-in over-temperature protection device.
8. Equipped with automatic fault detection and buzzer alarm function.
9. Appearance is exquisite, blue LCD display instant parameter information.
Principle
The device precisely controls the temperature of the heating module and the rotation speed of the oscillation platform driven by the DC brushless motor through the microprocessor. The metal module is uniformly heated to the set temperature, and the platform oscillates horizontally at the set Rotation speed and amplitude, so as to realize the thermostatic incubation and mixing of the samples placed on the module.
Applications
It is suitable for experimental operations that require mixing, shaking and thermostatic incubating heating of laboratory consumables such as microtubes, PCR plates, deep well plates, and microwell plates.
Standards
The data did not mention specific compliance criteria.
Steps
1. Turn on the power supply.
2. Set the required parameters such as temperature, Rotation speed and running time through Touchscreen.
3. Place the consumables containing the samples on the corresponding metal module.
4. Start the device and start running.
5. After the run, remove the sample.
Notice
● Power supply voltage meets equipment requirements (AC220V/120V, 50/60Hz).
● When the equipment is running, do not touch the heating module to avoid burns.
● When cleaning and disinfecting, please disconnect the power supply and wait for the module to chill down.
Do not place consumables on the device that exceed the specified capacity or do not match the module.
● If the device alarms, please check and troubleshoot according to the prompts before using it.
