Overview
HUXI RWD100E/20030034 LED overhead Stirrer is a laboratory equipment suitable for mixing medium and high viscosity liquids. The product is capable of high load, long-term continuous operation, outstanding performance, and automatic overload and abnormal protection to ensure laboratory safety.
Features
1. LED screen display, Rotation speed can be coarse and fine-tuned, and Rotation speed can also be adjusted during the operation of the instrument.
2. Motor soft start, smooth operation, effectively prevent sample overflow.
3. The closed enclosure effectively prevents liquid from splashing into the instrument, ensuring the safe operation of the experiment.
4. Configure the Impeller penetration hole, the user does not need to adjust the installation height of the instrument, just adjust the installation position of the stirring rod.
5. Provide a variety of Impellers and brackets to choose from.
Principle
The overhead Stirrer uses a motor to drive the stirring rod and blade swirl/spin to mix medium and high viscosity liquids in the container. The motor adopts soft start technology to run smoothly, and the stirring speed is precisely controlled by stepless speed regulation to adapt to different viscosity and mixing requirements.
Applications
Chemical synthesis, physical and chemical analysis, petrochemical, cosmetics, health products, food, biotechnology
Standards
Protection Rating: IP42
Steps
1. Select the appropriate Impeller according to the characteristics of the liquid to be stirred and install it.
2. Insert and fix the stirring rod through the penetration hole at the bottom of the instrument.
3. Turn on the power supply.
4. Rotation speed coarse adjustment and fine adjustment setting through LED screen and control knob.
5. Start the equipment to start stirring, and the Rotation speed can be adjusted as needed during operation.
6. Turn off the power after stirring, remove the Impeller and clean it.
Notice
• Power supply voltage in 100-240VAC range. Frequency 50/60Hz.
• Equipment should be used under Ambient Temperature 5~ 40 ℃ and relative humidity ≤ 80%.
• Impeller clamping diameter range is 0.5~ 10mm, please do not use beyond the range.
• The device has an overload protection function. When triggered, there will be a sound prompt and automatically stop. You need to check the cause before using it.
• Pay attention to the non-slip pad at the bottom of the device to ensure smooth placement.
Processing capacity is up to 40L, and the maximum viscosity of the liquid does not exceed 50000mPa · s.
Do not let liquids splash into the inside of the instrument to ensure safety and equipment life.
