Overview
HUXI RWD100E/20030047 LED overhead Stirrer is a laboratory equipment suitable for mixing medium and high viscosity liquids. The product is capable of high load, long-term continuous operation, outstanding performance, and automatic overload and abnormal protection to ensure laboratory safety.
Features
1. LED screen display, Rotation speed can be coarse and fine-tuned, and Rotation speed can also be adjusted during the operation of the instrument.
2. Motor soft start, smooth operation, effectively prevent sample overflow.
3. The closed enclosure effectively prevents liquid from splashing into the instrument, ensuring the safe operation of the experiment.
4. Configure the Impeller penetration hole, the user does not need to adjust the installation height of the instrument, just adjust the installation position of the stirring rod.
5. Provide a variety of Impellers and brackets to choose from.
Principle
The device mixes medium to high viscosity liquids by driving the Impeller swirl/spin motor. The motor uses a soft start mode for smooth operation and automatic protection against overloads and abnormalities.
Applications
Chemical synthesis, physical and chemical analysis, petrochemical, cosmetics, health products, food, biotechnology
Standards
Protection Rating: IP42
Steps
1. Select the appropriate Impeller according to the mixing requirements.
2. Install the stirring rod through the Impeller penetration hole and adjust it to the appropriate position.
3. Use a wrench chuck to secure the Impeller.
4. Turn on the power supply and set the required Rotation speed through the LED screen and speed control knob.
5. Start the equipment to stir.
6. Rotation speed can be adjusted as needed during the mixing process.
7. Turn off the power after stirring.
Notice
● Power supply voltage in 100-240VAC range.
● Equipment Permissible Ambient Temperature is 5~ 40 ℃, relative humidity ≤ 80%.
Do not use under conditions exceeding the maximum viscosity (50000mPa · s) or Processing capacity (40L).
● Note that the diameter range of the drill chuck clamping is 0.5 to 10mm.
The device has an overload protection function. When a sound prompt appears and it stops automatically, please check the load condition.
● Use non-slip mats to ensure that the equipment is firmly placed.
● Please select the appropriate Impeller type according to the liquid characteristics and container.
Please pay attention to the Protection Rating (IP42) when cleaning to avoid large amounts of liquid splashing into the inside of the instrument.
