Overview
HUXI LCD overhead Stirrer is a laboratory equipment suitable for mixing medium and high viscosity liquids. Models include RWD100/20030004/20030012. The product adopts self-locking chuck and self-developed Cube lifting fixed clip, which can be capable of high load and long-term continuous work. It has automatic protection function for overload and abnormal conditions to ensure laboratory safety. Mainly used in chemical synthesis, physical and chemical analysis, petrochemical, cosmetics, health products, food, biotechnology and other fields.
Features
1. LCD screen display, Rotation speed and time can be coarsely adjusted, Working time can be fine-tuned under working conditions
2. Speed range 30-2200rpm, constant Rotation speed, high and low speed controllable
3. Adopt brushless DC motor for long-term safe operation
4. Overload and motor protection, if there is an abnormality, automatically cut off the circuit and alarm
5. Configure Impeller penetration hole, no need to adjust the installation height of the instrument
6. The torque can be automatically adjusted according to the sample viscosity
7. Multiple Impellers and Bracket Available
Principle
The Stirrer drives the Impeller swirl/spin through a brushless DC motor to achieve mixing of medium and high viscosity liquids. With stepless speed regulation, the torque can be automatically adjusted according to the change of sample viscosity to ensure the mixing effect. In the event of overload, short circuit or abnormal situation, the system will automatically cut off the circuit and alarm to ensure the safety of the experiment.
Applications
Chemical synthesis, physical and chemical analysis, petrochemical, cosmetics, health products, food, biotechnology
Steps
1. Select the appropriate Impeller and install it into the self-locking chuck
2. Rotation speed and Working time set by LCD screen
3. Start the equipment and start the mixing operation
4. Working time can be fine-tuned as needed during the working process
5. Turn off the equipment after mixing
Notice
• Power supply voltage within 100-240VAC range before use
• Ambient Temperature should be maintained between 5-40 ℃
• The relative humidity should not exceed 80%
• Note that the clamping diameter range of the Impeller is 0.5-10 mm
• The device will automatically stop when overload or abnormality occurs, please check the cause of the failure
• Do not use under conditions exceeding the maximum viscosity of 50000mPa · s
• Please pay attention to safety protection when using to ensure that the chuck protective cover and non-slip pad are in good condition
