Overview
DK-98-ⅱ series Electrically-heated thermostatic water bath is suitable for laboratories of industrial and mining enterprises such as units, Universities & colleges, scientific research departments and chemical printing and dyeing. It is used for experimental operations such as distillation, condensing, drying and thermostatic heating. This model is a single row six-hole design, using stainless steel Tank and Cold rolled steel plate box, with good durability and corrosion resistance.
Features
1. The shell is formed with good steel plate, and the surface is electrostatic spraying process, which is sturdy and durable.
2, liner and cover made of good stainless steel plate, strong corrosion resistance.
3, the use of U-shaped heating pipe in water direct heating, rapid heating, heat loss is small.
4. Single digital display (DK-98-II) or intelligent temperature controller (DK-98-IIA), easy to operate and effective to use.
5. PID control (DK-98-IIA).
6. Easy to operate, support fixed-value operation, regular operation, and automatic stop function.
7. Dedicated function keys enable temperature setting.
8, auxiliary menu, achieve over-rise alarm, deviation correction, menu lock.
9. Linear dispersion diagram display function.
Principle
The water bath is heated directly in the water through a U-shaped stainless steel heating tube to rapidly heat up the water in the Tank. Temperature setting and control is carried out through a single digital display or an intelligent thermostat, using a PID control algorithm (model DK-98-IIA) or a time proportional control (model DK-98-II) to maintain the water temperature near the set value and achieve thermostatic heating.
Applications
Universities & colleges, research departments, chemical printing and dyeing laboratories
Steps
1. Turn on the power supply (AC220V 50/60Hz).
2. Add an appropriate amount of water to the Tank.
3. Set the desired temperature by tapping the button.
4. Select a fixed-value operation or set a regular running time as required.
5, start the equipment, heating pipe to work.
6. The device automatically enters the thermostatic state after reaching the set temperature, or automatically stops after the timing ends.
Notice
* Before use, please ensure that the water in the Tank is sufficient to avoid dry burning.
* Do not exceed the Shelf load (5kg) limit.
* When the equipment is running, do not touch the heating parts and high temperature sink to prevent burns.
* Be sure to disconnect the power before cleaning and wait for the equipment to chill down completely.
* Do not use strong corrosion of Chemical Reagents directly clean the surface of the box.
* Power supply voltage must match (AC220V).
* If the device has an over-rise alarm, please check the temperature sensor and setting value.
