Overview
HUDA QT-E702-100B40 programmable humidity chamber is mainly used to simulate the high temperature, low temperature or heat and humidity environment that may be encountered during transportation, storage and use of electronic Instruments, new materials, electricians, vehicles, metals, electronic products, aerospace materials, etc., inspection materials, accessories or equipment High temperature resistance, cold resistance, moisture resistance performance and possible damage life reduction.
Features
1. The box is made of SUS304 stainless steel plate, which is corrosion-resistant and easy to clean
2. Explosion-proof door handle is easy and safe to operate
3. Ultra-fine fiberglass insulation system, reliable sealing
4. French Taikang Compressor with environmentally friendly refrigerant
5.P.I.D + S.S.R temperature and humidity coordinated control
6. Nickel-chromium alloy heating system and independent humidification system
7. Precision LCD programmable controller
8. Multiple security protection systems
9. Interface supports printing and communication
Principle
Adopt thermal equilibrate temperature control and isolation humidification system, coordinate the control of temperature and humidity through the same channel of P.I.D + S.S.R system, use French Taikang Compressor and environmentally friendly refrigerant to achieve low temperature environment, nickel-chromium alloy electric heating wire to achieve rapid heating, stainless steel humidifier to achieve humidity control, to ensure the test environment is accurate and stable.
Applications
Electronic Instruments, New Materials, Electrical, Vehicles, Metals, Electronics, Aerospace Materials
Standards
GB2423.1-2008/IEC6008-2-1-2007、GB/T 2423.2-2008、GJB150.3A－2009、GJB150.4A－2009、GB2423.22-2008、GBT 2424.5-2006、GB/T 10589-2008、GB/T2423.3-2008(IEC68-2-3)
Steps
1. Move the device to the designated position and fix the casters
2. Connect the power supply and check the device status
3. Set the test parameters through the touch screen
4. Place the sample on the adjustable sample rack
5. Start the test program
6. Monitor the test process through the observation window
7. Export the data after the test is completed
Notice
• Sample load-bearing should be evenly distributed and not exceed 20kg
• Ensure that the equipment is well grounded to prevent leakage
• Regularly check the automatic water replenishment device
• The equipment will automatically shut down after the fault alarm
• Check the refrigeration system pressure before use
• Keep the test hole sealing intact
• Avoid opening and closing doors frequently in extreme temperatures and humidity
