Overview
HUDA QT-E702-150B60 programmable humidity chamber is mainly used to simulate the harsh high temperature, low temperature or heat and humidity environment that may be encountered during transportation, storage and use of electronic Instruments, new materials, electricians, vehicles, metals, electronic products, aerospace materials, etc., inspection materials, accessories or equipment High temperature resistance, cold resistance, moisture resistance performance and possible damage life reduction.
Features
1. The box is made of SUS304 stainless steel plate, which is acid-resistant, corrosion-resistant and easy to clean
2. Explosion-proof door handle is easy and safe to operate
3. Ultrafine fiberglass insulation system, refined silicone rubber sealing
4. The bottom installation can fix the PU activity wheel, which is convenient for mobile positioning
5. SUS304 stainless steel sample holder, load-bearing ≥ 20kg
6.Double-decked Vacuum Reinforced Glass Viewing Window, Heating and Defrosting
7. France Taikang Compressor, the United States DuPont environmental protection refrigerant
8.P.I.D + S.S.R temperature and humidity coordinated control
9. Nickel-chromium alloy high-speed heating system
10. Precision LCD programmable controller
11. Chint brand main electrical components
12. USB data transfer interface, supports data storage and printing
13. Multiple security protection systems
Principle
Adopt thermal equilibrate temperature control and isolated humidification system, coordinate temperature and humidity control through P.I.D + S.S.R system, use French Taikang Compressor and binary low temperature circuit system to achieve accurate temperature control, nickel-chromium alloy heating system and independent humidification system to ensure rapid and stable Temperature and Humidity Response.
Applications
Electronic Instruments, New Materials, Electrical, Vehicles, Metals, Electronics, Aerospace Materials
Standards
GB2423.1-2008/IEC6008-2-1-2007、GB/T 2423.2-2008、GJB150.3A－2009、GJB150.4A－2009、GB2423.22-2008、GBT 2424.5-2006、GB/T 10589-2008、GB/T2423.3-2008(IEC68-2-3)
Steps
1. Move the device to the designated position and fix the casters
2. Connect Power and Necessary Interface
3. Set test parameters and procedures through the touchscreen
4. Place the sample and adjust the sample holder spacing
5. Start the equipment operation test
6. Monitor the test process through the observation window
7. Download and store data after the test is completed
Notice
• The sample load-bearing needs to be evenly distributed, and the single-point load-bearing does not exceed 20kg.
• Power supply voltage meets 220V requirements before equipment operation
• Regularly check the refrigerant and hydration system
• After the fault alarm, the equipment will automatically shut down, and it needs to be restarted after troubleshooting.
• Operating system where the use environment should meet the requirements of the controller
• Install thermal insulation accessories and sealing soft plugs in time after the test hole is used
