Overview
HUDA QT-E702-408B60 programmable humidity chamber is mainly used to simulate the harsh high temperature, low temperature or heat and humidity environment that may be encountered during transportation, storage and use of electronic Instruments, new materials, electricians, vehicles, metals, electronic products, aerospace materials, etc., inspection materials, accessories or equipment High temperature resistance, cold resistance, moisture and heat resistance performance and possible damage life reduction.
Features
1. The box is made of SUS304 stainless steel plate, which has the advantages of acid resistance, corrosion resistance, and easy cleaning
2. Equipped with explosion-proof door handle and ultra-fine fiberglass insulation system
3. Using French Taikang Compressor and American DuPont environmental protection refrigerant
4. Temperature and humidity control using P.I.D + S.S.R system co-channel coordinated control
5. Heating with nickel-chromium alloy high-speed heating wire
6. Adopt precision LCD display programmable temperature controller
7. Have a complete safety protection system
Principle
The equipment adopts thermal equilibrate temperature control mode, and simulates different temperature and humidity environments through the coordination of refrigeration system, heating system and humidification system. The control system realizes accurate temperature and humidity control through P.I.D + S.S.R system, and adopts a binary low temperature circuit system design, which is convenient for different temperature domains to use different Compressors for work.
Applications
Electronic Instruments, New Materials, Electrical, Vehicles, Metals, Electronics, Aerospace Materials
Standards
GB2423.1-2008/IEC6008-2-1-2007、GB/T 2423.2-2008、GJB150.3A－2009、GJB150.4A－2009、GB2423.22-2008、GBT 2424.5-2006、GB/T 10589-2008、GB/T2423.3-2008(IEC68-2-3)
Steps
1. Move the device to the designated position and fix it by moving the wheel
2. Connect the power supply and necessary external equipment
3. Set test parameters and procedures through the touchscreen
4. Place the sample and adjust the sample holder spacing
5. Start the equipment and start the test
6. Monitor the test process through the observation window
7. Export data through the interface after the test is completed
Notice
• Ensure that the equipment is installed on a stable ground
• Power supply voltage check before use
• Sample load should be evenly distributed and not exceed 20kg
• Regularly check refrigerant and humidification systems
• Pay attention to the status of the safety protection device when the equipment is running
• The equipment will automatically shut down after the fault alarm
• Keep the observation window clean to ensure clear observation
