Overview
HUDA QD-E710-IPX34-225 dripping test chamber is suitable for evaluating the protection performance of electrical product shells and seals in a rainy environment. This product adopts scientific design and can realistically simulate dripping, dripping, splashing, spraying and other test environments.
Features
1. The shell of the box is treated with stainless steel plate hairline, and the liner material is made of stainless steel light plate.
2. Large area visible Glass door, easy to observe the test chamber to be tested condition.
3. Adopt high-quality fixed PU movable wheel, which is convenient for users to move.
4. Sample stage with 350-degree pendulum pipe and 360-degree rotary rod water spray device, and adjustable Rotation speed.
5. Comprehensive Control system and the use of frequency conversion technology, so that the rainfall, the test rack rotation angle, the water spray swing rod swing angle and water spray swing Frequency can be automatically adjusted.
Principle
Control system is used to drive the swinging tube and the sample table to simulate the water spraying environment with different angles and intensities. Select the swinging tube of proper radius, make the height of the sample table at the diameter position of the swinging tube, and spray water to the sample through the water spraying hole on the swinging tube to test the protection performance of its shell and sealing parts under rain conditions.
Applications
Waterproof performance test of electrical product shell and sealing parts
Standards
GB/T4208、EC60529、GB2423,38-90、GB4706.32-2004、IEC-5129
Steps
1. Select a swinging tube with an appropriate radius and adjust the height of the sample stage so that the distance from the top of the sample to the nozzle is no more than 200mm.
2. Place the test sample on the sample table in the center of the semicircle of the pendulum tube.
3. According to the standard (such as IPX4), set the water Flow rate (0.07 L/min per hole), the swing angle of the pendulum pipe (such as 180 ° on both sides, about 360 ° in total) and the test time (such as continuous water spraying for 10 minutes).
4. Start the device for testing.
5. After the test is completed, verify whether the product meets the standard requirements.
Notice
* Before the test, the correct pendulum tube radius and setting parameters (such as swing angle, water Flow rate, test time) should be selected according to the standard requirements.
Make sure that the sample is placed in the correct position and the distance from the top to the sample nozzle is not greater than 200mm.
* Note that the water spray pressure should be maintained within the range of 80-150Kpa.
The test time can be set within 1-999,999 minutes as required.
