Overview
KESIONOTS KS-HW80C (150 ℃) humidity chamber is a testing equipment that can accurately simulate complex natural environments such as low temperature, high temperature, high temperature and high humidity, low temperature and low humidity. It is suitable for product Reliability testing in plastics, electronics, food, clothing, vehicles, metals, chemicals, building materials and other industries.
Features
1. With automatic calculation function
2. With fixed temperature and slope setting function
3. With hold, skip, standby and two sets of time signal output functions
4. With cold/heat engine start-up selection function
5. With temperature display value correction function
6. With temperature sensor calibration function
7. With Compressor automatic stop function
8. With reservation start/stop function
9. With power failure memory function: program data memory can be maintained for 6 months after power failure
10. Powerful network monitoring and control capabilities
11. With a capacity of 1000 programs, each of which can cycle through 999 steps
12. With fault alarm and cause, processing prompt function
13. With upper and lower limit temperature protection function
14. With self-diagnostic function
15. With PC link function
Principle
The equipment adopts a cascade refrigeration system, which consists of two relatively independent refrigeration systems, the high temperature part and the low temperature part, which are connected by evaporative condenser. The heating system is composed of high-power resistance wire. The temperature and humidity system is divided into two subsystems: humidification and dehumidification. The humidification adopts steam humidification method, and the dehumidification mainly adopts mechanical refrigeration and dehumidification method. The Sensor system adopts platinum resistance and Thermocouple measurement temperature, and the solid-state electronic Sensor measurement humidity.
Applications
Plastics, electronics, food, clothing, vehicles, metals, chemicals, building materials
Standards
GB5170、2、3、5、6-95、GB2423.1-89 (IEC68-2-1)、GB2423.2-89 (IEC68-2-2)、GB/T2423.3-93(IEC68-2-3)、GB/T423.4-93(IEC68-2-30)、GJB150.3(ML-STD0-810D)、GJB150.4(MIL-STD-810D)、GJB150.9-1986、GJB4.6-1983、GJB367.2-1987、GJB4.5-1983、GB10592-93、GB10586-93、GJB360.8-87(MIL-STD-202f)、GB/T5170.2-96、GB/T5170.5-96、YD1268-2003、UL1642、UN38.3、GB/T18287-2000、GB8897.4-2002、UL2054-2005、SJ/T 11169-1998、SJ/T11170-1998、YD1268.2-2003、QC/T743-2006、QC/T744-2006
Steps
1. Set program catalog management and test parameters
2. Select the operation mode: fixed value/program/link
3. Set the reservation start function
4. Perform timing control planning
5. Monitor actual operation Linear dispersion
6. Review historical data after completing the test
Notice
• Operation lock function prevents accidental touch from affecting experimental results
• Power supply voltage: 220V AC (+/- 10%)
• Must use air switch (40A), no knife switch or power socket
• The resistivity of humidification water needs to be ≥ 500MΩ
• The weight of the product rack does not exceed 20 kg
• Pay attention to the protection function of the safety device: air burn prevention, high voltage protection, overheating protection, overcurrent protection, etc
• Select the appropriate restart mode after power failure: interrupt, cold start, or heat start
